Service Instructions

Page 16
BasX PT1 and BasX TA1
BasX PT1 and BasX TA1 Remote Control
ENTER
DIGI ANA
FM
DIM
1
2
3
4
5
6
7
8
1. Transmit LED
This LED will ash red whenever a button on the remote control is pressed.
2. Power Button
This button is used to toggle the PT1 or TA1 between Standby and On modes.
Note: The Remote Control will only operate when the AC Power Switch on the rear panel of the
unit is On.
3. Navigation Ring / Buttons
In normal operation, pressing the Left and Right arrows will switch Inputs, and the Up and Down
arrows will raise and lower the Volume. When the Setup Menu is engaged, the arrows are used for
menu navigation.
4. Menu Button
This button toggles the Setup Menu on and o.
5. Mute Button
Press this button to mute the audio output; press it again to return the audio to its previous level.