Home Theater System User Manual

Page 9
Preparation
Attaching the base (XRT Tower models only)
Each X-Ref Tower model ships with an attractive base. The base is not only decorative,
but makes the X-Ref Towers much more difcult to tip over, and provides a mounting place
for the included carpet spikes if you choose to use them. We strongly urge all X-Ref Tower
owners to use the bases.
Position the base with the raised center area facing the speaker (with the side of the
base with the countersunk holes away from the speaker); insert and tighten the four bolts
(included).
If your X-Ref speakers are to be placed on a hard level surface (like a wood oor), use only
the bases. (You may add felt or rubber stick-on feet at the corners if you prefer).
If your X-Ref loudspeakers are to be placed on a soft surface (like carpet), or an irregular
surface (like rough concrete), the included carpet spikes should be inserted into the four
holes near the corners of the base. The spikes provide additional stability on soft surfaces
and can be adjusted and locked (using the locking nut) to level the speaker on irregular
surfaces.
Note: The carpet spikes should NOT be used on nished ooring (like hardwood or
linoleum) as they may damage the surface. If you wish to use the spikes for levelling
on such a surface, you can purchase small metal “foot plates” on which to sit the
spikes, or replace the spikes with special feet intended for delicate oors.
Bottom of
X-Ref Tower
Base
Carpet spike
(with nut)
Bolt