User manual

Page 14
XPA-100
Input Sensitivity (for rated power; 8 Ohm load):
1200 mV.
Gain:
29 dB.
Input Connections:
Unbalanced (RCA); balanced (XLR); one each.
Input Impedance:
47 kOhms.
Trigger:
Trigger Input: 5 - 20 V (AC or DC); <10 mA input current required.
Trigger Output: 12 VDC; can drive any load up to 50 mA.
Power Requirements:
115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (automatically detected and switched).
Front Panel Controls and Indicators:
Standby; push button (halo ring changes color to indicate Standby or On).
Status LEDs (two); blue LED illuminates for normal operation, red LED ashes during
power-on or when a fault occurs; (may be disabled by rear panel Status LED switch).
Rear Panel Controls:
AC Power switch; rocker switch (switches AC mains power).
Status LEDs switch; small slide switch on left (disables front panel Status LEDs and dims.
Standby button halo lighting).
Input selector; toggle switch (selects between balanced and unbalanced inputs).
Protection:
The XPA-100 is protected against excessive operating temperature, shorted speaker
connections, ground faults, and other common fault conditions.
Dimensions:
17” wide x 3.875” high x 19” deep (includes feet and binding posts).
Weight:
27 pounds unboxed (33 pounds boxed).