Owner's manual

Remove the round terminal nuts from the terminal posts on the back of the

speaker. Remove 1/4” to 3/8” of the insulation from the end of each speaker

wire. Insert the ends of the speaker wires into each terminal making sure to

observe proper polarity (typically, the positive wire is red, and the negative

wire is black). Verify the wires are in the correct terminal holes and replace

the terminal nuts. Tighten each nut so the wire is securely attached.

Attaching Speaker Wires

Mounting Speakers

To mount the speaker to the mounting plates on

the wall: 1.) Place the damping spacer on top of the

speaker’s lower mounting bracket as shown in the

illustration to the right; 2.) Line up the speaker’s

lower bracket to the lower wall mount bracket;

3.) Insert one hex bolt into the bottom hole on the

speaker’s mounting bracket and into the lower wall

bracket; 4.) Line up the speaker’s upper bracket

with the upper mounting bracket as shown in the

illustration below; 5.) Insert the other hex bolt

into the top hole on the

speaker’s upper mounting bracket and into the

upper wall bracket. e speaker should now be able

to pivot on both brackets. 6.) Use the included hex

wrench to tighten both hex bolts until the speaker

cannot pivot and is securely attached to both

brackets. Adjusting the pivot angle of the speaker

is as easy as loosening the two hex bolts, adjusting

the angle of the speaker, then tightening the bolts

to lock the speaker at the desired pivot angle.

Speaker Wires

Terminal

Posts

Terminal

Nuts

Back View of Speaker