EMPV-54WIT09
TABLE OF CONTENTS Instruction before installation 01 Preparing tools before installation 02 Size chart 03 Bathtub Plumbing Locator Diagram 04 Installation procedures 05 Care and Maintenance 08 Troubleshooting Guide 08
Instruction before installation WARNING : when usingthis tub,the following basic procautions should be followed: Avoid the risk of electrical shock Connect only to a circuit protected by a grount-fault circuitinnterrupter(GFCI).Grounding is required; All electrical connections should be made by a licensed electrician,in accordance with requirements of national electrical codes and procedures.
Preparing tools before installation Impact drill Spirit level Adjustable wrench Tape rule 19mm Sleeve Phillips screwdriver 5mm hexagonal key Glass Glue & Rob 10*100mm expansion bolts Art knife Waste bunker A hand saw Expansion tube Stainless steel screws 2
Size chart PRODUCT size 54.33"x30.31"x39.76" 54.33" 17.72" 30.31" 15.02" Shower Head 21.63" Switch Drainer 22.04" Head Restraint Drainer 19.68" 22.04" Water Line 45.48" 39.76" 42.91" 14.91" 7.97" 23.
Bathtub Plumbing Locator Diagram Five-hole socket (with a separate circuit for grounding, 10A current) Reserved Bathtub Drain Outlet ø50-ø100 Be sure to avoid the positions of the adjustable foot pads, the drain body, and the hard drain pipe.
Installation procedures Installation Step 1: Connecting Bathtub Water Supply and Drainage Pipes (Faucet Assembly) The bathtub's water supply pipes consist of cold water inlet and hot water inlet pipes. As shown in the diagram, connect the cold water pipe and the hot water pipe to the corresponding fittings reserved at the blade corners.
Installation Step 3: Installation of the U-shaped Handrail U-shaped Handrail U-shaped Handrail Stainless Steel Decorative Cover Rubber Washers Bathtub Surface Rubber Washers Accessories List: Stainless Steel Decorative Cover × (2) Bolts × (2) Rubber Washers × (2) Metal Washers × (2) Metal Washers Bolts Installation Step 4: Installation of the Backrest Bracket Central Axis Decorative Cover Bracket Legs Backrest Bracket Spindle Bathtub Surface Bolts Accessories List: Decorative Cover × (2) Bolts × (2)
Installation Step 6: Adjust the size of the door gap 1、When the doorway is small up and big down, adjust the adjusting foot under the door downward. 2、When the doorway is large and small, adjust the adjustable feet under the door upward. Installation Step 7: Door Handle Installation The door handle must be installed correctly in its position in order to avoid damage to the internal mechanisms of the door.
Care and Maintenance Walk-in bathtubs require regular maintenance to keep them clean and in top working condition. After using the old man's tank, wash it with water and dry it with a clean rag. Troubleshooting Guide SYMPTOMS PROBLEMS SOLUTIONS Door leaks slightly 1.Door lock is not closed tightly; 2.There is some debris on the door seal. 1.Close the door lock tightly; 2.Clean the debris on door seal. Water hose leaks 1.Rubber ring is not good; 2.
