Installation Guide

ManualsBrandsEmpava ManualsAppliances24 in. Single Gas Wall Oven with Convection in Stainless Steel

Do not use a steam cleaner

because the moisture can get into

the appliance thus make it unsafe.

GENERAL RECOMANDATION

• Important: Before any operation of cleaning and maintenance disconnect

the appliance from the electrical supply.

• It is advisable to clean when the appliance is cold and especially for cleaning the

enamelled parts.

• Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the

surfaces.

• Avoid using cleaning products with a chlorine or acidic base.

• The use of suitable protective clothing/gloves is recommended when handling,

cleaning this appliance.

WARNING

When correctly installed, your product meets all safety requirements laid down

for this type of product category. However special care should be taken around

the rear or the underneath of the appliance as these areas are not designed or

intended to be touched and may contain sharp or rough edges, that may cause

injury.

ENAMELLED PARTS

• All the enamelled parts must be cleaned with a sponge and soapy water or other

non-abrasive products.

• Dry preferably with a microfibre or soft cloth.

• Acidic substances like lemon juice, tomato sauce, vinegar etc. can damage the

enamel if left too long.

PAINTED PARTS AND SILK-SCREEN PRINTED SURFACES

• Clean using an appropriate product. Always dry thoroughly.

 IMPORTANT: these parts must be cleaned very carefully to avoid scratching and

abrasion.

 You are advised to use a soft cloth and neutral soap.

STAINLESS STEEL ELEMENTS

• Stainless steel parts must be rinsed with water and dried with a soft and clean cloth.

• For difficult dirt, use a specific non-abrasive product available commercially or a

little hot vinegar.

INSIDE OF OVEN

The oven should always be cleaned after use when it has cooled down.

The cavity should be cleaned using a mild detergent solution and warm water.

Suitable proprietary chemical cleaners may be used after first consulting with the

manufacturers recommendations and testing a small sample of the oven cavity.

Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity

surface.

NOTE: The manufacturers of this appliance will accept no responsibility for damage

caused by chemical or abrasive cleaning.

Let the oven cool down and pay special attention no to touch the hot heating

elements inside the oven cavity.

Before any operation of maintenance

disconnect the appliance from the

electrical mains supply.

WARNING

VERY IMPORTANT

CLEANING AND MAINTENANCE