INSTRUCTION MANUAL GAS COOKTOP Appliance Class: 3 Empava Item #: 30 " :EMPV-30GC0A2 EMPV-30GC0A5 36" : EMPV-36GC202 EMPV-36GC881 EMPV-36GC888 EMPV-36GC901 Distributed by: Empava Appliances Inc. 15253 Don Julian Rd, City of Industry, CA 91745 USA www.empava.
The instructions shall be marked with directions to the installer to leave them with the appliance and to the consumer to retain them for future reference.
WARNING: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. If the supply cord is damaged, it must be replaced by the manufacturer.
1 Contents Cooktop Description Important Information Operation Maintenance and Cleaning Troubleshooting Instructions for the Installer Important safety requirements Installation
This appliance shall be installed in accordance with the regulations in force and only used in a wellventilated space. Read the instructions before installing or using this appliance. The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or, in Canada, the Natural Gas and Propane Installation Code, CSA B149.1.
Cooktop Description EMPV-30GC0A2 Operating Instructions: Knob 1 is for burner 10 Knob 2 is for burner 9 Knob 3 is for burner 8 Knob 4 is for burner 7 Knob 5 is for burner 6 Figure 1 Total heat input: 37600Btu/hr EMPV-30GC0A 1.burner 6—6000Btu/hr in 2.56" 2.burner 7—10200Btu/hr in 3.74" 3.burner 8—13600Btu/hr in 5.20" 4.burner 9—6000Btu/hr in 2.56" 5.Burner 10—3400Btu/hr in 1.
Total heat input: 37600Btu/hr 3 EMPV-36GC881 Operating Instructions: Knob 1 is for burner 10 Knob 2 is for burner 9 Knob 3 is for burner 8 Knob 4 is for burner 7 Figure 4 Knob 5 is for burner 6 1.burner 6—10200Btu/hr in 3.74" 2..burner 7—6000Btu/hr in 2.56" 3.burner 8—13600Btu/hr in 5.20" 4.burner 9—6000Btu/hr in 2.56" 5..burner 10—3400Btu/hr in 1.
Total heat input: 37600Btu/hr EMPV-36GC901 Operating Instructions: Knob 1 is for burner 10 Knob 2 is for burner 9 Knob 3 is for burner 8 Knob 4 is for burner 7 Knob 5 is for burner 6 Figure 6 1.burner 6—10200Btu/hr in 3.74" 2.burner 7—6000Btu/hr in 2.56" 3.burner 8—6000Btu/hr in 2.56" 4.burner 9—3400Btu/hr in 1.77” 5.Burner 10—13600Btu/hr in 5.20" Total heat input: 37600Btu/hr 4 Important Information Read the instructions before installing or using this appliance.
necessary instructions concerning modification of the appliance to the conditions of use of the country. Installation Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible. The adjustment conditions for this appliance are stated on the label (or data plate). This appliance is not connected to a combustion products evacuation device.
The gas cooktop gets hot when it is in use. Children should be kept away until it has cooled. Children can also injure themselves by pulling pans or pots off the gas cooktop. CAUTION: This appliance is for cooking purposes only. It must not be used for other purposes, for example, room heating. 5 When Use This gas cooktop is intended for domestic cooking only. It is not designed for commercial or industrial purposes.
correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Operation Lighting Simply press the knob in, turn anticlockwise to ignition position(star icon) .
If you cannot light the flame even after several attempts, check the "cap" and “crown” (see diagram – figure 10) if they are in the correct position. To put the flame out, turn the knob to the symbol “O” Description: 1. Burner cap 2. Burner crown 3. Burner base 4. Ignition electrode 5. Thermocouple Figure 10 When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.
Figure 11 Re-ignition: If the flame is out for certain reasons, the safety device will cut off the gas power automatically. Turn the switch to " largest flame " position, then ignite again, you should wait for 30 seconds when you do that; Due to the air in the tong, there may be unsmooth ignition, revolve the switch to " largest flame " position and ignite again. Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the gas cooktop from the electricity supply.
The electric ignition is obtained through a ceramic "electrode" and a metal electrode. Keep these components very clean, to avoid lighting difficulties, and check that the burner crown holes are not obstructed. Thermocouple The thermocouple is very crucial for cutting gas supply in case of flame out during cooking, be sure to keep them in very clean condition. Maintenance instructions suggesting (We suggest to clean it every six months.
• The gas ring burns unevenly • Check the main jet is not blocked and the burner crown is clear of food particles. • Check the burner cap and crown have been replaced correctly, e.g. after cleaning. Instructions for the Installer Overall dimensions For Model EMPV-30GC0A2 EMPV-30GC0A5 EMPV-36GC202 EMPV-36GC881 EMPV-36GC888 EMPV-36GC901 Cut out dimensions Width Depth 29.90in 20.08in 36.02in 20.67in Width Depth 28.34in 18.30in 34.45in 19.
Important safety requirements Location The cooktops may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom, shower room or garage. Before making the cut out in the worktop ensure that there is a minimum distance of 2.17” between the rear edge of the cooktops and the wall. A minimum distance of 3.94” must be left between the side edges of the cooktops and any adjacent cabinets or walls.
A manual valve be installed in an accessible location in the gas line external to the appliance for the purpose of turning on or shutting off gas to the appliance. Warning：Turn the knob counterclockwise to adjust the flame, size, so that the flame does not float out of the container rim. If need to adjust the flame size from big to small when operation, turn the knob counterclockwise 90 degrees to the position.
Figure 14 Gas type LPG (Parts list) NG (Parts list) Nozzles Dia. (mm) Power (Btu/hr) Quantity Nozzles Dia. (mm) Power (Btu/hr) Quantity Wok burner(Triple ring burner) 1.00 13600 1 1.50 13600 1 Rapid burner 0.85 10200 1 1.28 10200 1 Semi rapid burner 0.65 6000 1 0.97 6000 1 Auxiliary burner 0.50 3400 1 0.
8) Similarly, when use in NG status, turn the marked NG arrow upwards and tighten it to the screw cap (see Figure 18). Repeat the above operation. The outlet pressure requires to be 4 ± 1in wc. 9) After the conversion is completed, the conversion label in the accessory bag needs to be attached next to the original label.
WHEN THE GAS COOKTOP IS FIRST INSTALLED Once the gas cooktop has been installed, it is important to remove any protective materials, which were put on in the factory. Any gas installation must be carried out by a competent person. Important: When installing the gas cooktop above a built-in oven, the oven should be placed on two wooden strips; in the case of a joining cabinet surface, remember to leave a space of at least 1.77” x 22.05” at the back.
Cut Out dimensions The dimensions of the cut-out are given in the diagram. (Dimensions are given in inch.) For model: 36GC202 36GC881 For model:30GC0A2, 30GC0A5 36GC888 Figure 18 Electrical connections 36GC901 Figure 19 14 Any electrical work required to install this gas cooktop should be carried out by a qualified electrician or competent person. Check the last letter of your model to know the electrical supply type: A is for AC,D is for DC.
the grounding prong from this plug.
Figure 24(for the appliance with five burners) Use with D.C battery 15 When your cooktop is the one fitted with D.C supply device only, you are suggested to use one 1.5V battery. Be sure that the battery is well fixed then you can follow the “Lighting” procedure. Take off the battery if you won’t use the cooktop for a long time. Check the working performance every time before cooking.
16 Simply fill in the fields below and print form. Send Completed Form to: Customer Service:(888)-682-8882 Empava Appliances Inc. Warranty/ Registration Dept. 15253 Don Julian Rd City of Industry,CA,91745 WARRANTY CARD PLEASE READ AGREEMENT BEFORE SIGNING Click Here Keep this copy for yourself.
City ________________________ ST _____ ZipCode ______________________ E-mail: ____________________________________________________________ Signature:_________________________________________ Date: ____________ My signature above acknowledges that I have read, fully understand, and accept this limitedwarranty agreement. Must return within 14 days of purchase with copy of dated register receipt. WARRANTY CARD COPY (For your records) Empava Appliances Inc. Warranty/ Registration Dept.
