Use and Care Manual

Installation

Selection of installation equipment

• Cut out the work surface according to the sizes shown in the drawing.

• For the purpose of installation and use, a minimum of 1.97in space shall be

preserved around the hole.

• Be sure the thickness of the work surface is at least 1.18in. Please select

heat-resistant work surface material to avoid larger deformation caused by the heat

radiation from the hotplate. As shown below:

Warning: The work surface material must use the impregnated wood or other

insulation material.

L(in) W(in) H(in) D(in) A(in) B(in) X(in)

EMPV-IDC12

11.42 20.47 2.28 2.13 10.63 19.29 1.97mini

EMPV-IDC24

23.62 20.47 2.28 2.13 22.05 19.29 1.97mini

EMPV-IDC30

29.92 20.47 2.28 2.13 28.74 19.29 1.97mini

EMPV-IDC36

35.43 20.47 2.28 2.13 33.86 19.29 1.97mini

Under any circumstances, make sure the cooktop is well ventilated and the air inlet and

outlet are not blocked. Ensure the cooktop is in good work state. As shown below.

Note: The safety distance between the hotplate and the cupboard above the hotplate

should be at least 760mm.