PIN-HOLE FREESTANDING TUB INSTALLATION INSTRUCTIONS
PIN-HOLE FREESTANDING TUB INSTALLATION INSTRUCTIONS WARNING: Risk of electric shock. Do not permit electrical appliances near any bathtub when bathtub contains water. WARNING: Risk of electric shock. Connect only to a circuit protected by a GroundFault Circuit-Interrupter (GFCI). WARNING: Risk of injury or property damage. Please read all instructions thoroughly before beginning installation, including the following requirements. WARNING: Risk of electric shock.
PIN-HOLE FREESTANDING TUB INSTALLATION INSTRUCTIONS NOTICE: Do not support the weight of the bath by the rim. NOTE: Carefully unpack and inspect the new bath for damage before installation. If there is damage do not install the bath; contact your dealer. Make sure the flooring offers adequate support for your bath. 2. Install the Bath Install the Plumbing Install the faucet valve. Check the drain connections for leakage. 3. Make the Electrical Connections WARNING: Risk of electric shock.
PIN-HOLE FREESTANDING TUB INSTALLATION INSTRUCTIONS or other metal tools. Use a powder-type detergent on a damp cloth to provide mild abrasive action to any residual plaster. Cleaning and Maintenance: System drain and purge air immediately after use. Re-tart the air pump after the bath has been drained. 2 minutes later stop it, the purge system would blows any residual water out of the air channels. Do not use powdered cleaners unless the cleaner is fully dissolved in water.