SYMPTOMS PROBLEMS SOLUTIONS Water pump will not start. 1.Air hose connected to the pneumatic switch is loose; 2.Pneumatic switch does not work flexible; 3.Disconnected to the power or defective wiring; 4.There are some debris stuck the pump impeller; 5.Water level does not reach the minimum water level of the bathtub; 1.Tighten the connection of air hose and pneumatic switch; 2.Adjust the pneumatic switch; 3.Insert the plug; 4.Clean the debris; 5.
8 1
Before connect bathtub water inlet pipe, first open water pipe for a period of time,then put filter screen to ensure that the debris will not Filter enter the bathtub pipe. So screen that we can effectively extend the life of the fitting.
Open Close Close Open 6 3
B Water level protection Water jets Right Left Light OK Air jets Lockout button Inline Heater Confirm ON/OFF Open OK Close OK A Switch valves B HOT COLD C water jets Inline Heater Air jets light up down Switch marked with "H" is hot water switch; Switch marked with "C" is cold water switch; Switch marked with icons is transferable switch which can be rotated to waterfall or sprinkling style.
