Installation Instructions Instructions d'installation lnstrucciones de instalacion 30 11 Single and Double Built-in Oven Four encastre de 3011 Single and Double Horno empotrado de 3011 Single and Double IMPORTANT: Save for local electrical inspector's use. IMPORTANT : Conserver pour consultation par l'inspecteur local des installations electriq ues. IMPORTANTE: Guardelo para uso del inspector electrico local.
TABLE OF CONTENTS OVEN SAFETY ..................................................................................................... 1 INSTALLATION REQUIREMENTS.......................................................................... 2 Tools and Parts................................................................................................................ 2 Location Requirements.................................................................................................. 3 Opening Dimensions......
State of California Proposition 65 Warnings: WARNING: This product contains one or more chemicals known to the State of California to cause cancer. WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other reproductive harm. INSTALLATION REQUIREMENTS TOOLS AND PARTS Gather the required tools before starting installation. Read and follow the instructions provided with any tools listed here.
TECHNICAL DATA OVEN DIMENSION MODEL Single Built-in 30" (76 cm) Oven Double Built-in 30" (76 cm) Oven Electrical Ratings and Maximum Connected Load @ 240 Volts 60 Hz @ 208 Volts 60 Hz 20 4800 17.3 3605 8500 30.7 6381 HCW3260AES Amperes Watts Amperes Watts HCW3285AES 35.4 LOCATION REQUIREMENTS IMPORTANT: Observe all governing codes and ordinances. • Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance with oven.
PRODUCT DIMENSIONS Single Oven Double Oven b b a c a c e d e Letter Single Oven Dimensions a b c d e 4 d Double Oven Dimensions 287/16" (72.2 cm) Height (overall) 513/16" (130.0 cm) Height (overall) 281/2" (72.4 cm) Width (recessed) 28½" (72.4 cm) Width (recessed) 273/16" (69 cm) Height (recessed) 4915/16" (126.8 cm) Height (recessed) 231/2" (59.7 cm) Depth (recessed) 231/2" (59.7 cm) Depth (recessed) 297/8" (75.9 cm) Width (overall) 297/8" (75.
OPENING DIMENSIONS Single Oven - Installed in Cabinet and Installed Undercounter d Double Oven Installed in Cabinet Electrical Junction Box Location NOTE: Junction box may be located in adjacent cabinet 4" c d 4" c a a b b 4" c a f e b e f e Single Oven Undercounter w/o Cooktop Single Oven in Cabinet Double Oven in Cabinet Width (cutout) 285/8" (72.7 cm) 285/8" (72.7 cm) 285/8" (72.7 cm) Height (cutout) 271/2" (70 cm) 271/2" (70 cm) 501/4" (127.6 cm) Depth (cutout) 24" (61.
ELECTRICAL REQUIREMENTS If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate and wire gauge is in accordance with local codes. Do not use an extension cord. In U.S.A. : Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/ NFPA No. 70-latest edition and all local codes and ordinances.
WARNING Electrical Shock Hazard The electrical power to the oven branch circuit must be shut off while line connections are being made. Do not use an extension cord with this appliance. Electrical ground is required on this appliance. The free end of the green wire (the ground wire) must be connected to a suitable ground. This wire must remain grounded to the oven. If cold water pipe is interrupted by plastic, non metallic gaskets, union connections or other insulating materials, DO NOT use for grounding.
If local codes permit grounding through the electrical supply neutral, connect both the white neutral wire and the green ground wire from the oven to the white neutral electrical supply wire. • Check with a qualified electrical installer if you are not sure the oven is properly grounded. • Single Oven - When a 4-wire, single phase 120/240 volt, 60 Hz.
STEP 2 - REMOVE THE OVEN DOOR IMPORTANT: The oven door is heavy and fragile, and the door front is glass. To avoid oven door glass breakage, use both hands, and grasp only the sides of the oven door to remove. 1. Open the oven door. 2. Locate the door latches in both corners of the oven door, and rotate the latches forward to the unlocked position. a b a Locked b Unlocked 3. Grasp the edges of the oven door with both hands and push the oven door fully closed.
STEP 3 - INSTALL OVEN WARNING Excessive Weight Hazard Use two or more people to move and install oven. Failure to do so can result in back or other injury. 1. Using two or more people, grasp the ceiling of the oven cavity and lift the oven onto a table or platform even with the cutout opening. NOTE: The surface must be able to support the following weight: • • Single Oven : 160 lb (73 kg) Double Oven: 290 lb (132 kg) 2. Feed the flexible electrical supply conduit from the oven to the junction box.
STEP 4 - MAKE ELECTRICAL CONNECTION To properly install your oven, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. DIRECT WIRE WARNING Electrical Shock Hazard Disconnect power before servicing. Improper connection of aluminum house wiring and copper appliance leads can result in an electrical hazard or fire.
4. Route the flexible electrical supply conduit from the oven to the junction box through a UL listed or CSA approved conduit connector. 5. Tighten screws on conduit connector. 3-WIRE CONNECTION (GROUNDED NEUTRAL) - U.S.A. ONLY WARNING Electrical Shock Hazard Grounding through the neutral conductor is prohibited for new branch-circuit installations (1996 NEC); mobile homes; and recreational vehicles, or in an area where local codes prohibit grounding through the neutral conductor.
2. Connect the two black wires b together using a UL listed wire connector. 3. Connect the two neutral (white) wires c and the ground (green or bare) wire d (of the oven cable) using a UL listed wire connector. 4. Connect the two red wires g together using a UL listed wire connector. 5. Install junction box cover. 4-WIRE CONNECTION (UNGROUNDED NEUTRAL) - U.S.A. AND CANADA 4-Wire Cable from Home Power Supply IMPORTANT: Use the 4-wire cable from home power supply in the U.S.
STEP 5 - MOUNT THE OVEN 1. Slide the oven completely into the cabinet until the back surface of the front frame touches the front wall of the cabinet. Center the oven within the cabinet cutout. NOTE: Push against seal area of the oven front frame when pushing the oven into the cabinet. Do not push against the outside edges. a b a Mounting Frame b Mounting Frame Hole 2. There are two holes, one on each side of the front frame that surrounds the oven cavity. Drill 1/8" (3.
STEP 7 - COMPLETE INSTALLATION 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Dispose of/recycle all packaging materials. 3. Check Operation of Oven. • • • • Turn on power. Press BROIL. Set the temperature. Press START. NOTE: If oven(s) does not operate, check the following: • • • Household fuse is intact and tight; or circuit breaker has not tripped. Electrical supply is connected.
