Specifications

5. CROSSOVER ADJUSTMENTS

5.1 SELECTING THE OPERATION MODE

You must select and set the appropriate operation mode before you can attempt any of the crossover

frequency adjustments. This setting depends on the speaker system connected to the amplifier. Select

the appropriate operation mode as follows:

➡ Select HIGHPASS, if the speaker system is a component-, coaxial- or triaxialtype.

➡ Select LOWPASS in case of a kickbass system, or a subwoofer system.

Selecting the appropriate operating mode for each channel pair makes sure, that the speakers con-

nected to the amplifier outputs will only receive filtered signals, so the speakers will only have to oper-

ate in the frequency band they can reproduce best.

Note: If you own a head-unit, that features an integrated DSP controlled crossover, it is recommended

to use the DSP based crossovers of the headunit. In this case, you have to set the operation mode to

fullrange.