Specifications

1. DESIGN FEATURES

■ DIGITAL CAR AUDIO AMPLIFIER for a cross-over controlled amplification of satellite speaker

systems, kickwoofers and subwoofer systems

■ REMOTE LOWPASS LEVEL CONTROL to set the subwoofer volume level from the driver’s seat

■ REGULATED MOSFET POWER SUPPLY to sustain very high output power into low impan-

dance loads

■ 1 OHM LOAD STABILITY to drive speaker systems with very low impedance, sustaining very

high power output levels

■ ELECTRONIC CROSSOVER with 12 dB/oct. or 18/24 dB/oct. slope steepness and fully varia-

ble cit-in / cut-off frequencies for highpass, bandpass or subsonic filtering of the individual channels

■ 2AWG POWER INPUT TERMINALS for direct connection of 35mm

main power wires

■ ADVANCED PROTECTION CIRCUITRY to safe-guard the amplifier from short-circuits at the

speaker outputs, DC offset voltage at the outputs and overheating of power electronics

■ ADJUSTABLE RCA INPUT SENSITIVITY from 200mV to 6V to provide a good match with the

line-output levels of almost any head-unit

■ EXTERNAL FUSES on the input side-panel, equipped with Maxi type fuse holders

EM Digital 4/5-CH Manual 2004 26.03.2004 11:39 Uhr Seite 5