Owner`s manual
32925-3-0115 Page 11
3. Liftthecompleteburnerandvalveassemblyupward,thenturn
it sideways in replace opening to gain easy access to the
junctionbox. Youmayremovethecompleteburnerandvalve
assemblyasshowninFigure 12.
Figure 12
4 Thejunctionboxislocatedontheendofthereplace.Remove
the5/16”Hexscrewthatsecuresthejunctionboxtotherebox,
andremovethejunctionbox.See Figure 13. Run romex wire
throughtherightrearcornerofthereplaceandintotherebox
area.Securewiringwiththeromexconnectorasrequiredand
install the duplex receptacle as shown in Figure 14. Attach the
blackwiretothebrassscrewsideofthereceptacle,andthe
white wire to the opposite side. Secure the incoming ground
wire under the green ground screw provided on the receptacle.
Figure 13
Figure 14
5. IfonlyinstallingtheLK5AccentLightkit,thenremovethe7/8”
diameterknockoutinthesideofthejunctionbox,installthe
7/8” diameter protective grommet, and connect the wiring with
wire nuts as shown in Figure 14.
receptacle is not used.
6. Oncethejunctionboxwiringiscompleted,re-installthejunc-
tionboxintothelowerrightcornerofthereboxcavityusing
the screws removed in step 4 as shown in Figure 15.
USED FOR LIGHT
ACCESSORY ONLY
Figure 15
7. Reinstalltheburnerandvalveassemblyandreattachthescrews
removed in step 2. See Figure 11.
8. For VFL(L,Z)48SP90: Reconnect the wire from the switch on
theheatshieldandputtheshieldbackinplace.
(VFLL48SP shown)