Owner`s manual

32925-3-0115Page 20
Keepthecontrolcompartmentandburnerareacleanbyvacuuming
orbrushingareaatleasttwiceayear.
THE FIREPLACE CAN GET VERY HOT – HANDLE ONLY WHEN
COOL.
Alwaysturnoffgastothepilotbeforecleaning.Forrelighting,refer
tolightinginstructionslocatedontheratingplateofthereplace.
Neverobstructtheowofthecombustionandventilationair.Keep
thefrontofthereplaceclearofallobstaclesandmaterials.
Anintermittentpilotmayrequiremorefrequentbatterychanges
thanamillivoltpilot.Toreplacethebatteriesinanintermittent
unit, follow these steps:
1. Remove the outer glass. See Figures 30 - 32.
2. Remotetheoptionalglassmediafrominsidethereplace.
3. Liftandsetasidetheburnercover.
4. Lift the heat shield that is in front of the valve.
Note:Thebatterybackupandremotereceiverarelocatedunder
the heat shield.
5. ReplacethefourAAbatteriesineach.
6. Replace the items removed in steps 1 through 3.
MAINTENANCE
CLEANING AND SERVICING
        
      
and/or sooting.
TURN OFF HEATER AND ALLOW TO COOL BEFORE
CLEANING.
Remove any optional decorative covers or decorative glass material.
Gloves are recommended.


• Donotusecleaninguidtocleananypartofheater.
• Glassshouldbecleanedwithammonia-freecleaner.Ammonia
will etch or stain glass when heated.
• Removelooseparticlesanddustfromtheburner,controlsand
grate.
• Inspectandcleanburnerairintakehole.Removelintorparticles
withbrush.Failuretokeepairintakeholecleanwillresultin
sootingandpoorcombustion.


• Inspectandcleanburnerairintakehole.Removelintorparticles
withvacuumorbrush.Failuretokeepairintakeholecleanwill
resultinsootingandpoorcombustion.
• Inspectandcleanallburnerports.
• InspectODSpilotforoperationandaccumulationoflintatair
intakeholes.
• Verifyamepatternforproperoperation.
• Verifysmoothandresponsiveignitionofmainburner.
Cleaning and Pilot Maintenance

When the pilot has a large yellow tip ame, clean the Oxygen
Depletion Sensor as follows:
1. CleantheODSpilotbylooseningnutBfromthepilottubing.
Whenthisprocedureisrequired,graspnutAwithanopenend
wrench.
2. Use canned air to blow through the holes indicated by the
arrows.Thiswillblowoutforeignmaterialssuchasdust,lint
andspiderwebs.UseawrenchtoholdNutAasyoutighten
Nut B.
Millivolt Pilot
Figure 27

Figure 28
WARNING
   


3. Ifintermittentpilotstopsworking,cleanamesensorC(Fig-
ure 28) with a damp cloth.
4. Ifintermittentpilotignitordoesnotspark,cleanignitorelec-
trode D (Figure 28) with a damp cloth.
Figure 29