Owner`s manual

32925-3-0115 Page 27
FRBC - MILLIVOLT CONTROL SYSTEM
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
ATTEMPT TO INSTALL OR OPERATE
INTRODUCTION
This remote control system was developed to provide safe, reli-
able,anduser-friendlyremotecontrolsystemforgasheatingap-
pliances.
Thesystemcanbe operatedmanuallyfrom thetransmitter.The
system operates on one of 255 security codes that are pro-
grammed into the transmitter at the factory.
Thetransmitteroperatesona12Vbattery(included)madespe-
cicallyforremotecontrolsandelectroniclighters.Installthe12V
batterysuppliedwiththeunitintothebatterycompartment.
TRANSMITTER
Figure 42
Alwaysusealkalinebatteries.Theyperformbetterandlastlonger.
ThetransmitterhasONandOFFfunctionsthatareactivatedby
pressingeitherbuttononthefaceofthetransmitter.Whenabut-
ton on the transmitter is pressed, a signal light on the transmitter
illuminatesbrieytoverifythatasignalhasbeensent.Uponinitial
use, there may be a delay of three seconds before the remote
receiverwillrespondtothetransmitter.Thisispartofthesystem’s
design.Ifthesignallightdoesnotilluminate,checkthepositionof
thetransmitter’sbattery.
REMOTE RECEIVER
Figure 43
The remote receiver operates on 4AA-size 1.5V batteries. It is
recommended thatALKALINE batteries be used for longer bat-
tery life and maximum microprocessor performance. IMPORTANT:
Neworfullychargedbatteriesareessentialforproperoperationof
the remote receiver.
The remote receiver houses the microprocessor that responds to
commands from the transmitter to control system operation. The
remote receiver has a 3-position slide switch for selecting the
MODE of operation: ON/REMOTE/OFF
• WiththeslideswitchintheONposition(towardtheLEARN
button), the system will remain on until the slide switch is
placed in the OFF or REMOTE position.
• WiththeslideswitchintheREMOTEposition(centered),the
system will only operate if the remote receiver receives com-
mands from the transmitter.
• With the slide switch in the OFF position (away from the
LEARNbutton),thesystemisoff.
 
           -

         
        
-
ceiver inoperative.