Owner`s manual

32925-3-0115 Page 29
GENERAL INFORMATION
MATCHING SECURITY CODES
Eachtransmittercanuseoneof255uniquesecuritycodes.It
maybenecessarytoprogramtheremotereceivertoLEARNthe
securitycodeofthetransmitteruponinitialuse,ifbatteriesare
replaced, or if a replacement transmitter is purchased from your
dealerorthefactory.Whenmatchingsecuritycodes,besure
slidebuttononthereceiverisintheREMOTEposition;thecode
will NOT “LEARN” if the slide switch is in the ON or OFF posi-
tion. Program the remote receiver to LEARN a new security code
bypushingandreleasingthelearnbutton.Asingle"beep"will
sound.Pressthe"ON"buttonontheremotecontrol,untilthree
"beeps"sound.Thethree"beeps"arethesignalthatthereceiver
has learned the new code. When an existing receiver is matched
to a new transmitter, the new security code will override the old
one.
The microprocessor that controls the security code matching pro-
cedureiscontrolledbyatimingfunction.Ifyouareunsuccessful
inmatchingthesecuritycodeontherstattempt,wait1-2min-
utesbeforetryingagain–thisdelayallowsthemicroprocessorto
resetitstimercircuitry–andtryuptotwoorthreemoretimes.
BATTERY LIFE
Lifeexpectancyofthealkalinebatteriesislongerandtheperform
betterthanotherbatteries.Checkandreplaceallbatteriesannu-
ally. When the transmitter no longer operates the remote receiver
fromadistanceitdidpreviously(i.e.,thetransmitter’srangehas
decreased)ortheremotereceiverdoesnotfunctionatall,thebat-
teriesshouldbechecked.Itisimportantthattheremotereceiver
batteriesarefullychargedandprovidescontinuousoutputvoltage
of a least 5.3 volts. The length of the wire between the remote
receiver and gas valve directly affects the operating performance
oftheremotesystem.Thelongerthewire,themorebatterypower
isrequiredtodeliversignalsbetweentheremotereceiverandthe
gas valve. Recommended length is no longer than 20 feet. The
transmittershouldoperatewithaslittleas5.0voltsbatterypower.
TROUBLE SHOOTING
Ifyouencounterproblemswithyourreplacesystem,theproblem
maybewiththereplaceitselforitcouldbewiththeECSremote.
Review the replace manufacturer’s operation manual to make
sureallconnectionsareproperlymade.Thenchecktheoperation
of the ECS remote in the following manner:
• MakesurethebatteriesarecorrectlyinstalledintheRECEIV-
ER. One reversed battery will keep receiver from operating
properly.
• CheckbatteryinTransmittertomakesurecontactsaretouch-
ing(+)and(-)endsofbattery.Bendmetalcontactsinfortight-
ert.
• BesureRECEIVERandTransmitterarewithin20’-25’operat-
ing range.
• KeepRECEIVERfromtemperaturesexceeding130° F. Bat-
tery life shortened when ambient temperatures are above
130° F.
• IfRECEIVERisinstalledintightlyenclosedmetalsurround,
theoperatingdistancewillbeshortened.
RECEIVER ADJUSTMENT – RECOMMENDED ADJUSTMENT
 NOTE:Theslidebutton,WhiteorBlack,coverstheADJ
access hole when installed.
A. To adjust at the receiver, use a small slotted screwdriver. Turn
theadjustmentscrewcounter-clockwiseabout5degreesora
maximumof1/8turn.Thisshouldcorrectthedistanceprob-
lem.
B. Ifthatdoesnotcorrecttheproblem,returnadjustmentscrew
tooriginalpositionandthenturnadjustmentscrewclockwise.
Thisadjustmentisliketuningyourradio.Ifyoukeepturningthe
adjustment screw, in either direction, you will go past the proper
setting (tuning).
Figure 45
SPECIFICATIONS
BATTERIES:
Transmitter 12V (A23)
Remote Receiver
6V-4ea.AA1.5Alkaline
FCCIDNo.’s:transmitter-K9L1002TX;
Receiver - K9L3001RX
OperatingFrequency:303.875MHZ
CanadianISCIDNo.’s:transmitter-2439102728;
Receiver - 2439 102 728A
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR
ANY RADIO OR TV INTERFERENCE CAUSED BY UNAU-
THORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH
MODIFICATIONSCOULDVOIDTHEUSER’SAUTHORITY
TO OPERATE THE EQUIPMENT.
FRBC - MILLIVOLT CONTROL SYSTEM