Owner`s manual

32925-3-0115 Page 35
PROFLAME - IP CONTROL SYSTEM

Thisfunctionwilllockthebuttonstoavoidunsupervisedoperation.
To activate this function, press the MODE and the UP Arrow But-
ton at the same time (Figure 59).
To de-activate this function, press the MODE and the UP Arrow
Button at the same time.
Figure 59
LOW BATTERY POWER DETECTION

Thelifespanoftheremotecontrolbatteriesdependsonvarious
factors: quality of the batteries used, the number of ignitions of
theappliance,thenumberofchangestotheroomthermostatset
point, etc.
WhentheTransmitterbatteriesarelow,aBatteryIconwillappear
on the LCD display of the Transmitter (Figure 60)beforeallbat-
terypowerislost.Whenthebatteries arereplacedthisIconwill
disappear.
Figure 60
Receiver
ThelifespanoftheReceiverbatteriesdependsonvariousfactors:
qualityofthebatteriesused,thenumberofignitionsoftheappli-
ance,thenumberofchangestotheroomthermostatsetpoint,etc.
When the Receiver batteries are low, No “beep” will be emitted
from the Receiver when it receives an On/Off command from the
Transmitter.ThisisanalertforalowbatteryconditionfortheRe-
ceiver.Whenthebatteriesarereplacedthe“beep”willbeemitted
from the Receiver when the ON/OFF Button is pressed (See Ini-
tialization of The System).
MANUAL BYPASS OF THE REMOTE SYSTEM
IfthebatteriesoftheReceiverorTransmitterarelowordepleted,
theappliancecanbeturnedonmanuallybyslidingthethreeposi-
tion slider switch on the Receiver to the ON position.
Thiswillbypasstheremotecontrolfeatureofthesystemandthe
appliancemainburnerwillcomeonifthegasvalveisinthe“On”
position.