Owner`s manual

ManualsBrandsEmpire Heating Systems ManualsDomestic AppliancesDV-55SPP

Page 1

INSTALLATION INSTRUCTIONS

AND

OWNER’S MANUAL

WARNING: If not installed, operated and main-

tained in accordance with the manufacturer’s

instructions, this product could expose you to

substances in fuel or from fuel combustion which

can cause death or serious illness.

FAN TYPE

VENTED

WALL FURNACE

MODEL

FAW-55SPP

Installer: Leave this manual with the appli-

ance.

Consumer: Retain this manual for future refer-

ence.

— Donotstoreorusegasolineorotheramma-

ble vapors and liquids in the vicinity of this or

any other appliance.

— WHAT TO DO IF YOU SMELL GAS

 • Donottrytolightanyappliance.

 • Donottouchanyelectricalswitch;donot

use any phone in your building.

 • Immediatelycallyourgassupplierfroma

neighbor’s phone. Follow the gas suppli-

er’s instructions.

 • Ifyoucannotreachyourgassupplier,call

theredepartment.

— Installation and service must be performed by

aqualiedinstaller,serviceagencyorthegas

supplier.

WARNING: If the information in these instruc-

tionsarenotfollowedexactly,areorexplosion

may result causing property damage, personal

injury or loss of life.

Summary of content (12 pages)

PAGE 1
INSTALLATION INSTRUCTIONS AND OWNER’S MANUAL FAN TYPE VENTED WALL FURNACE MODEL FAW-55SPP WARNING: If the information in these instructions are not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Installer: Leave this manual with the appliance. Consumer: Retain this manual for future reference.
PAGE 2
Introduction Always consult your local Building Department regarding regulations or ordinances which apply to the installation of a vented wall furnace. Instructions to Installer 1. Installer must leave instruction manual with owner after installation. 2. Installer must have owner fill out and mail warranty card supplied with furnace. 3. Installer should show owner how to start and operate furnace and thermostat. Warning: Any change to this furnace or its control can be dangerous.
PAGE 3
SAFETY INFORMATION FOR USERS OF LP-GAS Propane (LP-Gas) is a flammable gas which can cause fires and explosions. In its natural state, propane is odorless and colorless. You may not know all the following safety precautions which can protect both you and your family from an accident. Read them carefully now, then review them point by point with the members of your household. Someday, when there may not be a minute to lose, everyone’s safety will depend on knowing exactly what to do.
PAGE 4
Ventilation and Combustion Air Wall furnaces shall be installed in a location in which the facilities for ventilation permit satisfactory combustion of gas and proper venting under normal conditions. In buildings of conventional frame, brick, or stone construction without tight storm windows and doors, infiltration is normally adequate to provide air for combustion and draft hood dilution.
PAGE 5
8” x 12” (203mm x 305mm) boot. Remove duct and cut to proper length. 8. Attach 6” x 10” (152mm x 254mm) duct to inner casing with (6) #10 x 1/2” (13mm) screws provided. 9. Insert rear register into 8” x 12” (203mm x 305mm) boot. Attach rear register to wall with (2) #10 x 1” (25mm) screws provided.
PAGE 6
(914mm) plug assembly. Insert 7/8” (22mm) strain relief bushing into the 7/8” (22mm) hole in the side panel. Attention! The 7/8” (22mm) strain relief bushing is located within the same yellow envelope as the Installation Instructions and Owner’s Manual. Attaching Furnace to Wall When attaching furnace to the wall remove that portion of baseboard and molding on the wall which is behind the furnace.
PAGE 7
On a new installation with air in the gas line, it is suggested that a match be used. The match will light the pilot faster than the piezo under this condition. Proper Pilot Flame The correct pilot flame (Figure 6) will be blue, extending past the thermocouple. The flame will surround the thermocouple just below the tip. Natural gas pilots require adjusting when the inlet gas pressure is above 5” w.c. (1.245kPa).
PAGE 8
Vent Safety Shutoff System This appliance must be properly connected to a venting system. This appliance is equipped with a vent safety shutoff system. Warning: Operation of this wall furnace when not connected to a properly installed and maintained venting system or tampering with the vent safety shutoff system can result in carbon monoxide (CO) poisoning and possible death. This furnace is equipped with a manual reset vent safety switch.
PAGE 9
FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
PAGE 10
Please Note: When ordering parts, it is very important that part number and description of part coincide. Index No. Part No. Description Index No. Part No.
PAGE 11
12428-7-1109 Page 11
PAGE 12
Model No. FAW-55 may be vented as shown. The vent cap must be at least 12 feet (3.7m) above the floor. Clearance to combustible construction is held by the fixed spacers at 1 inch (25mm) with B-1 vent pipe. Installation must conform to local codes. 4” (102mm) Round (all parts purchase locally except in item 2) 1. Type B-1 round pipe 2. Part No. DV-648, 4” (102mm) oval-to-round flue adapter kit (see accessories) 3. Single story type B-1 gas vents require a baseplate and one pair of ceiling plate spacers. 4.