Owner`s manual

26591-1-1209 Page 11
OPTIONAL EMPT SERIES MANTLE INSTALLATION - PENINSULA MODELS ONLY
MANTEL SHELF
SUPPORT
FRONT CANOPY
REAR CANOPY
END CANOPY
END SHIELD
CANOPY CORNER TIE
47 7/8”
(1216 MM)
30 1/8”
(765 MM)
5 7/8”
(149 MM)
Figure 5
Figure 6
Figure 7

          
EMPT series Mantel top is to be used.
Note:

Attention: For installation of the EMPT Mantel base and/or Mantel top
components, reference the assembly instructions included with the man-
tel.
Attention:
the EMPT mantel. Once through the wall, the vent system may be run
vertically or continue with a horizontal termination. Reference the vent-
ing section for additional mantel information.
Installing the 3-Piece Canopy and End Shield
Prior to installing the Peninsula mantel, install the 3-piece canopy and
End Shield in conjunction with the (4) Mantel Corner Brackets (included
with the Mantel Top) as shown in Figure 5a. Refer to the instructions
included with the EMPT Mantel Top for additional installation details.
1. Install (2) of the Mantel Corner Brackets at the vent end corners
           


2. Position the Rear Canopy with the mitered corner to the open end

Mantel Corner Bracket. Align the holes in the canopy with the cor-
ner bracket and loosely install a #10 x 1/2" Hex Head screw to re-
tain.
3. Position the Front Canopy with the mitered corner to the open end
-
ner Bracket. Align the holes in the Canopy and Corner Bracket and
loosely install a #10 x 1/2" Hex Head screw to retain.
4. Place the other (2) Mantel Corner Brackets on top of the Front and

a #10 x 1/2" screw through the corner bracket and canopy, then into
the pilot holes provided. Do not tighten the screws.
5. Install the End Canopy by sliding it under the Open End Mantel Cor-

Shield above the End Canopy and Mantel Corner Brackets, align
holes, then loosely secure all three parts with #10 x 1/2" screws to

6. Adjust the canopies left to right as needed so that the mitered cor-
ners meet, then tighten all previously installed screws to secure end
shield, canopies, and mantel corner brackets.
 -
ets at the underside of the canopy corners as illustrated by Figure
5a. Use a Phillips screwdriver to install two (2) #8 x 1/2 black
sheet metal screws to attach each corner bracket. Before tightening
screws, align the canopy mitered corners together then secure.
Figures 5 and 6 show placement of the corner brackets, canopies, and

top and base.
CANOPY CORNER TIE
END CANOPY
FRONT CANOPY
Figure 5a