Owner`s manual

26591-1-1209 Page 17
INSTALLATION
Note: 
Attention:         
mantel base.
Attention: If a base or mantel is not used and the appliance is
installed directly on carpeting, tile or other combustible material

panel extending the full width and depth of the appliance. The
vertical dimension must be adjusted when a metal or wood panel
is placed beneath the appliance.
Finishing (Figures 16 and 17)
Finish the walls with the material of your choice. Figure 3 on page
10 shows the minimum vertical and corresponding maximum
horizontal dimensions of mantels or other combustible projections

Only non-combustible materials may be used to cover the black

      
or modify the air inlet/outlet louvers in any manner.
Provide adequate clearances around air openings into the
combustion chamber.
Caution:
surround (top and sides) are sealed, a 300°F minimum sealant
material must be used. These joints are not required to be sealed.
Only non-combustible material (using 300°F minimum adhesive if

Flush Wall Installation - See Through Models
Figure 16
Flush Mount Mantel Installation - See-through Models Only
(Figure 15)



hex-head screws supplied in hardware package to attach nailing

Figure 15
Framing (See Figure 12)

place. Framing should be positioned to accommodate wall covering
        
constructed of 2 x 4 lumber or heavier. The framing headers may

CAUTION: MEASURE FIREPLACE DIMENSIONS AND
VERIFY FRAMING METHODS, AND WALL COVERING
DETAILS BEFORE FRAMING CONSTRUCTION
BEGINS.
Framing dimension "A" (Figure 12) includes the clearance
       
      

NAIL OR OTHER
SUITABLE FASTENER
FRAMING
63/8”(162 mm)
OF NON-COMBUSTIBLE MATERIAL
FINISHED WALL
FRONT TRIMOR NON-
COMBUSTIBLE MA TERIAL
(INSTALLA TION IS OPTIONAL)
JOINT BETWEEN FINISHED
WALL AND UNIT SEALED
WITH 300° F, 149°CSEALANT
MATERIAL (SEALANT IS OPTIONAL)