Owner`s manual

26591-1-1209Page 40
        



2 1/2” (64mm) beyond the vinyl siding kit or wall. See Figure
57.

needs to be used.
9. Mark or wrap tape completely around the tubes at the marked points
to help in making a true cut. Do not crimp or enlarge tubes.
10. From outside: Push the 6 5/8” (168mm) diameter inlet tube/mount-
ing plate onto end of rigid venting system to correct position. Fasten
the outside mounting plate to the vinyl siding kit or wall with (4)
10 x 1 1/2” screws. (Ensure upward slope).
11. From inside: Attach the inlet tube to the collar on the back of

screws.

and diagram (Figure 58).

-
tem). Hold the tube by the seam and push in using a perpendicular
“rocking” motion. This ensures the seam on the tube stay intact.
14. Fasten vent cap end using (3) 10 x 1/2” screws to mounting
plate.
Sealing 4” (102mm) Diameter Flue Outlet Tube
7. Remove outside mounting plate with tube attached from wall. Mark
and cut the extra length of the 6 5/8” (168mm) diameter tube from
the opposite end. Do not crimp or enlarge tube.
OUTSIDE WALL
MEASURE
VINYL SIDING KIT DV822
OUTSIDE MOUNTING
PLATE
EXT.WALL
SURFACE OR
VINYL SIDING KIT
FLUE
PIPE
CUT
2½”
BEYOND EXTERNAL
WALL SURFACE OR
VINYL SIDING KIT
Figure 56
Figure 57
1
”
VENT CAP END
APPLY SEALANT
ON THE INSIDE
DO NOT PLACE
OVERLAPPED
SECTION OVER
THE SEAM IN THE TUBE
Figure 58
Note:

venting system.
DVVK-4RE VENT KIT INSTALLATION INSTRUCTIONS (continued)