Owner`s manual

26591-1-1209 Page 45
Placement of the glowing embers (rockwool) is very individual and
light coverage of the areas indicated will provide your best effects.
We recommend separation of the rockwool by hand and to make

Place just enough embers on the burner to obtain the glow and a

Do not place rockwool over large port areas.
Rockwool should not be placed in the area of the pilot assembly.
Over time, the rockwool will break down and new rockwool will
need to be placed to recreate the original glowing embers effect.
Remove all old rockwool from the appliance and apply new
rockwool as shown in Figure 63.
Note: Only the rockwool supplied with this unit or ordered in
accordance with the Parts List on page 53 should be used on
this burner. See the Parts List on page 53 to order replacement
rockwool.
Optional Platinum Embers (PE-20-1) may also be used with this

PLACEMENT OF GLOWING EMBERS
Place ember material only
over port areas as shown
Do not cover any large ports with
ember material (glowing embers)
TOP VIEW
Figure 63