Owner`s manual

26591-1-1209Page 46
Before you begin: Do not handle the logs with your bare hands!
Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean opera-
tion of this heater. Sooting and other problems may result if the

-
ed with the logset. Logset approved for use in the DVP36(S,P)P
-
rately.
Flames from the pilot (rear right back side of the pan burner) as

is installed.



NOTE:
go up and down.
Glowing embers (rockwool) can cover the pan burner in areas
as shown in Figure 63, but very little is necessary to cover these

orange and stringy. Apply just enough to obtain slow glow and a

During manufacturing, fabricating and shipping, various

bonding agents. These chemicals are not harmful, but may produce
annoying smoke and smells as they are burned off during the initial
operation of the appliance, possibly causing headaches or eye or
lung irritation. This is a normal and temporary occurrence.
The initial break-in operation should be 5 to 10 minutes on (at
the highest setting) then let cool for 10 to 15 minutes. Repeat this
On/Off cycle two to three times to cure sealants. Provide additional
ventilation by opening windows or doors to allow odors to dissipate.
Any odors remaining after this initial break-in will be slight and
will disappear with continued use.
PERIODIC CLEANING – Refer to parts diagram for location
of items discussed below.
 
           
attachment.
         

from inside burner box.
          
particles with brush. Failure to keep air intake hole clean will
result in sooting and poor combustion.
ANNUAL CLEANING/INSPECTION – Refer to parts diagram
for location of items discussed below.
          
particles with vacuum or brush. Failure to keep air intake hole
clean will result in sooting and poor combustion.
 
 
 
 
 
up to the level of openings in burner top.
OPERATION INSTRUCTIONS/FLAME APPEARANCE