Owner`s manual

26591-1-1209Page 52
PLEASE NOTE
It is normal for appliances fabricated of steel to give off
some expansion and/or contraction noise during the start
up or cool down cycle. Similar noises are found with your
furnace heat exchanger or car engine.


undetected oil from the manufacturing process.
Please ensure that your room is well ventilated - open all
windows.


installed, place fan in the “OFF” position during this time.
IMPORTANT: Turn off gas before servicing appliance. It is

ups at the beginning of each heating season.
 
Keep the control compartment, logs, and burner areas surrounding
the logs clean by vacuuming or brushing at least twice a year.
Cleaning Procedure
1. Turn off pilot light at gas valve.
2. Remove glass front. (See Glass Removal)
3. Vacuum burner compartment.
4. Reinstall glass front.
5. Ignite pilot. (See Lighting Instructions)
6. Operate the pilot burner. If it appears abnormal call a service
person.
 
The appliance and venting system should be inspected before

Inspect the external vent cap on a regular basis to make sure

Glass Cleaning
It will be necessary to clean the glass periodically. During start-up
condensation, which is normal, forms on the inside of the glass and
causes lint, dust and other airborne particles to cling to the glass

glass. It is therefore recommended that the glass be cleaned two or
three times with a non-abrasive household cleaner and warm water

should be cleaned two or three times during each heating season
depending on the circumstances present.
General Glass Information
WARNING: Do not operate appliance with the glass front
removed, cracked or broken. Replacement of the glass should


be used for replacement. The glass replacement should be done by

WARNING:
1. The use of substitute glass will void all product warranties.
2. Care must be taken to avoid breakage of the glass.
3. Under no circumstances should this appliance be operated without
the glass front or with a broken glass front. Replacement of the
glass (with gasket) as supplied by the manufacturer should be

4. Do not abuse the glass by striking or hitting the glass.
WARNING: Do not use abrasive cleaners on glass. Do not
attempt to clean glass when glass is hot.
Glass Removal and Replacement (Figure 67)
1. Remove top louver, grasp louver and pull forward.
2. Lower bottom louver.
 
4. Remove glass frame.
 
 
7. Align clips on top louver with slots on front posts. Replace top

8. Close bottom louver.
Louver Removal and Installation
1. Remove top louver, grasp louver and pull forward.
2. Lower bottom louver.
3. Align clips on top louver with slots on front posts. Replace top

4. Close bottom louver.
GLASS FRAME
ASSEMBLY
GLASS FRAME CLAMP
Figure 67
MAINTENANCE AND SERVICE