Owner`s manual

26591-1-1209 Page 57
ACCENT LAMP
12 VOLT SIDE
120 VOLT SIDE
TRANSFORMER
(R9344)
CORDSET
(R6159)
RHEOSTAT ASSEMBLY
(18879)
Your Direct Vent Gas Fireplace comes equipped with an "Accent
Lamp." The light has been pre-wired and is controlled from the
Rheostat.
If in the event the lamp or lens needs to be replaced, follow the
instructions below:
1. Unplug the Accent Lamp/transformer from the junction box

2. Remove the four screws that secure the lens frame. This frame
retains the glass lens. The bulb can now be accessed.
Note:          
with clean dry cloth.
The lamp will pull straight out of the socket. Replace with 10
Watt/12 Volt Halogen bulb.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens.
"Light Leakage" from the upper area may be observed. The holes
in the lamp housing are necessary for ventilation and must not be
covered.
Figure 68 - Accent Lamp Wiring
COVER
LAMP
GLASS
GASKET
BEZEL
Figure 69 - Accent Lamp Parts
Part Number Description
23116 Cover
R9340 Lamp
R9658 Gasket
R9341 Glass
R9342 Bezel