Owner`s manual
31449-4-1113Page 64
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR
EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR
LOSS OF LIFE.
A. This appliance has a pilot which must be lighted with
the remote control. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING, smell around the appliance area for
gas.Besuretosmellnexttotheoorbecausesomegas
inheavierthanairandwillsettleontheoor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Donotuseanyphoneinyourbuilding.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions. If you can not reach your gas
supplier,calltheredepartment.
C. Use only the remote control to operate the gas control
knob.Never usetools. Ifvalvedoesnotoperate,don't
trytorepairit,callaqualiedservicetechnician.Force
orattemptedrepairmayresultinareorexplosion.
D. Donotusethisapplianceifanyparthasbeenunderwater.
Immediatelycallaqualiedservicetechniciantoinspect
the appliance and to replace any part of the control system
andanygascontrolwhichhasbeenunderwater.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
1. Turn off all electric power to the appliance if service is to
beperformed(ifapplicable).
2. Openbottomlouverassembly.
3. LocateOn/Offgascockandturnclockwiseto
"OFF." Do not force.
4. Closebottomlouverassembly.
RF STANDING PILOT LIGHTING INSTRUCTIONS
1. STOP!Readthesafetyinformationabove.
2. Turn OFF electric power to the appliance.
3. Openbottomlouverassembly.
4. Turn gas cock counterclockwise
to "ON"
position.
5. Wait ten minutes to clear out any gas. Then smell for gas,
includingneartheoor.Ifyousmellgas,STOP!Follow
"B"inthesafetyinformationaboveonthislabel.Ifyou
do not smell gas, go to the next step.
6. Turn ON electric power to the appliance.
7. Findpilot-Followmetaltubefromgascontrol.Thepilot
isbehindtheburnerontherightside.
8. Usingtheremotecontrol,turnmainameto"ON."Ifthe
pilot does not light within 60 seconds, stop and go to Step
5.
9. Refer to remote control instructions for detailed information,
control features, and operation. Note: There is a switch on
the side of the Electronic Control Module that allows for
a continuous standing pilot mode or an intermittent pilot
mode. See appliance manual for location of this switch.
If the pilot or burner does not stay lit (in the standing
pilotmode),stopandimmediatelycallaqualiedservice
technician or gas supplier.
10. If the burner or pilot does not operate properly after
several tries, turn the gas control knob clockwise
to "OFF" and call your service technician or
gas supplier.
11. Closebottomlouverassembly.
12. Operationofthegasvalve,blower,and/oroptionallight
mustbecontrolledbyusingthehandheldremotecontrol.
Refer to remote instructions for detailed operation
information.
OFF ON