Owner`s manual

30329-0-0312 Page 13
Flush Wall Installation
Figure 14
CombustibleSurroundInstallation
Figure 15
VentRuns(Figures16,17,and18)
In planning the installation for the replace, it is necessary to install
certain components before the appliance is completely positioned
and installed. These include the direct vent system, gas piping for
the appliance and the electrical wiring. (If the fan option is used.)
The appliance can be mounted on any of the following surfaces:
1. A at, hard combustible (burnable) surface.
2. A raised wooden platform.
3. Four (4) corner supports. (Example: Four (4) concrete masonry
blocks.) These supports must be positioned so they contact all
four (4) perimeter edges on the bottom of the unit.
VERTICAL,90°ELBOWWITHHORIZONTALTERMINATION
Figure 16
Attention: Cold climate installation recommendation: When
installingthisunitagainstanon-insulatedexteriorwall,itis
recommendedthattheouterwallsbeinsulatedtoconform
toapplicableinsulationcodes.