Owner`s manual
30329-0-0312Page 64
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:IFYOUDONOTFOLLOWTHESEINSTRUCTIONSEXACTLY,AFIREOR
EXPLOSIONMAYRESULTCAUSINGPROPERTYDAMAGE,PERSONALINJURY,OR
LOSS OF LIFE.
A. This appliance has a pilot which must be lighted with
theremotecontrol.Whenlightingthepilot,followthese
instructions exactly.
B. BEFORELIGHTING,smellaroundtheapplianceareafor
gas.Besuretosmellnexttotheoorbecausesomegas
inheavierthanairandwillsettleontheoor.
WHAT TO DO IF YOU SMELL GAS
• Donottrytolightanyappliance.
• Donottouchanyelectricalswitch.
• Donotuseanyphoneinyourbuilding.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions. If you can not reach your gas
supplier,calltheredepartment.
C. Use only the remote control to operate the gas control
knob.Never usetools. Ifvalvedoesnotoperate,don't
trytorepairit,callaqualiedservicetechnician.Force
orattemptedrepairmayresultinareorexplosion.
D. Donotusethisapplianceifanyparthasbeenunderwater.
Immediatelycallaqualiedservicetechniciantoinspect
the appliance and to replace any part of the control system
andanygascontrolwhichhasbeenunderwater.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
1. Turn off all electric power to the appliance if service is to
beperformed(ifapplicable).
2. Openbottomlouverassembly.
3. LocateOn/Offgascockandturnclockwiseto
"OFF." Do not force.
4. Closebottomlouverassembly.
RF STANDING PILOT LIGHTING INSTRUCTIONS
1. STOP!Readthesafetyinformationabove.
2. Turn OFF electric power to the appliance.
3. Openbottomlouverassembly.
4. Turn gas cock counterclockwise to "ON"
position.
5. Waitten(10)minutes toclearoutany gas.Thensmell
forgas,includingneartheoor.Ifyousmellgas,STOP!
Follow"B"inthesafetyinformationaboveonthislabel.
Ifyoudonotsmellgas,gotothenextstep.
6. Turn ON electric power to the appliance.
7. Findpilot-Followmetaltubefromgascontrol.Thepilot
isbehindtheburnerontherightside.
8. Usingtheremotecontrol,turnmainameto"ON."Ifthe
pilotdoesnotlightwithin60seconds,stopandgotoStep
5.
9. Refertoremotecontrolinstructionsfordetailedinformation,
controlfeatures,andoperation.Note:Thereisaswitchon
the side of the Electronic Control Module that allows for
a continuous standing pilot mode or an intermittent pilot
mode. See appliance manual for location of this switch.
If the pilot or burner does not stay lit (in the standing
pilotmode),stopandimmediatelycallaqualiedservice
technician or gas supplier.
10. If the burner or pilot does not operate properly after
several tries, turn the gas control knob clockwise
to "OFF" and call your service technician or
gas supplier.
11. Closebottomlouverassembly.
12. Operationofthegasvalve,blower,and/oroptionallight
mustbecontrolledbyusingthehandheldremotecontrol.
Refer to remote instructions for detailed operation
information.
PILOT
FLAME
SENSOR
ELECTRODE
OFF ON