Owner`s manual

30329-0-0312 Page 73
ACCENT LAMP
12 VOLT SIDE
120 VOLT SIDE
Your Luxury Direct Vent Gas Fireplace comes equipped with our
"Accent Lamp." The light has been pre-wired and is controlled from
the Rheostat.
If in the event the lamp or lens needs to be replaced, follow the
instructions below:
1. Unplug the Accent Lamp/transformer from the junction box
inside the replace.
2. Remove the four screws that secure the lens frame. This frame
retains the glass lens. The bulb can now be accessed.
Note: Do not handle the lamp (bulb) with bare ngers, protect with
clean dry cloth.
The lamp will pull straight out of the socket. Replace with 10 Watt/12
Volt Halogen bulb.
When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens.
"Light Leakage" from the upper area may be observed. The holes
in the lamp housing are necessary for ventilation and must not be
covered.
Figure 80 - Accent Lamp Wiring
COVER
LAMP
GLASS
GASKET
BEZEL
Figure 81 - Accent Lamp Parts