Operator's Manual

16
Marker is Breaking paintballs in the breech - Ball detents may be sticking open.
- Bolt guide o-orings are not sealing
- Eyes are dirty
Remove both ball detent covers and clean the ball detents with a cloth. You may also add some grease to the outer
surface of the detents to make sure they are not sticking within the covers.
Check if small bolt guide o-ring’s are worn or damaged. If bolt slides off bolt guide from gravity only replace o-rings
Clean the eyes as described on page 12.
Marker is shooting slower than set ROF - Eyes are dirty The eye logic sets max rof to 8bps when the eyes are dirty. Clean the eyes as described on page 12.
Velocity is Low/Inconsistent or velocity drops
during rapid fire
- Poppet o-ring is not properly lubricated or damaged
- Bolt guide o-rings are not properly lubricated or damaged or worn out
- Marker pressure may be flucuating
To lubricate or replace poppet o-ring first remove gas source. Remove bolt system. Unscrew back cap all the way then
push poppet and spring out towards the rear of the bolt guide. Apply grease to the o-ring on the brass poppet body but
keep the poppet face clean. Replace o-ring if there is damage Reinstall poppet and spring in rear of bolt guide and screw
back cap all the way in. Unscrew back cap 3/4 a turn and set velocity.
Lubricate the small bolt guide o-rings and bolt as described on page 10. Replace O-rings if damaged or if bolt can
slide off too easily. Bolt should not slide down bolt guide from only gravity when bolt system is held facing the ground.
Pressure should be set to around 200psi. If pressure drops during rapid fire and doesn’t recover to set pressure between
each shot try screwing in tank all the way or try a different tank.
12. DIAGRAMS AND PARTS LIST