Specifications

18
REMOVAL OF GRIP FRAME
- Using a 1/8" Allen key, remove both grip frame screws turning counter-
clockwise.
- Gently pull down frame from body.
INSTALLATION OF GRIP FRAME
- Inspect the air transfer tube O-ring and lightly grease. As you install the
grip frame, make sure the solenoid wires do not get pinched and hold the
trigger in to prevent the trigger activation magnet from getting damaged.
Gently push grip frame back on and line up the air transfer tubes.
- When frame is back on, use the 1/8" Allen key and tighten the (2) grip frame
screws clockwise.
REMOVAL, INSTALLATION AND CLEANING OF BALL DETENTS
- Using a 5/64" Allen key, insert Allen key into detent cover and turn
counter-clockwise.
- Clean the detents with a damp cloth and apply a small amount of grease
to the outer sides of the detents if sticking is a issue.
- Installation is the reverse of the removal. Do not over tighten the Ball
Detent covers!
Note: Be careful not to lose any of the detent parts as they are small.