Specifications

24
Breaks paint
in chamber
Loader pushing too hard. Try a different loader, such as the Empire Magna Drive Loader. If using a Halo
series or Empire Reloader B series loader, try installing an Empire Magna
Clutch Upgrade Kit.
Bolt or bolt guide O-rings may be worn. Air blowing past worn O-rings can easily break paintballs in the feedneck.
Replace the bolt O-rings and the smaller 3 bolt guide
O-rings and apply fresh grease.
Bolt front seal may be missing. Make sure the bolt front seal is in place and has a light application of grease
to reduce friction.
Check valve may be missing. Make sure the check valve is in place. Without the check valve, the forward
force on the bolt is too great and can be too hard on the paintballs.
Ball detents may be dirty or worn. Clean the ball detents. If necessary, apply a small amount of grease around
the outer surface to reduce friction inside the ball detent covers. Replace if
tips are worn down.
Regulator pressure may
be set too high.
Lower regulator pressure.
Cycles very slow Bolt or bolt guide O-rings
may need grease.
Clean off old grease from the bolt and bolt guide O-rings, as well as the bolt
front seal, and apply fresh grease.
Rate-of-Fire setting may
be adjusted too low.
Raise Rate-of-Fire setting.
Loader may not be feeding fast. Check your loader’s batteries or use a faster loader.
Inconsistent
velocity
Pressure may be set too low. Low pressures have difficulty supplying enough volume to maintain a
constant velocity. Do not lower your Mini’s regulator pressure below 180 psi.