Specifications

9
www.empirepaintball.com
REGULATOR ADJUSTMENT
If adjustments are needed use a 3/16" Allen key and insert it into the regulator
adjustment screw. This is located in the front of the regulator.
-To Increase pressure turn Clockwise.
-To Decrease pressure turn Counter-clockwise.
Notes:
-Always watch the gauge as you are adjusting the pressure.
-Do NOT use CO2!!!
-The use of a low pressure output compressed air tank is recommended.
-The Bottomline Regulator should not be disassembled.
-Never set the regulator above 200 psi.
ADJUSTING THE VELOCITY
At the back of the MINI main body is the Bolt Guide Cap. The Allen screw in
the bolt guide cap serves as your velocity adjuster. Confirm that the pressure
on your MINI Bottomline Regulator is at 200 PSI. Then you can increase or
decrease the velocity on your MINI by tightening or loosening the velocity
adjustment screw with a 1/4" inch Allen wrench.
-To Increase Velocity
Unscrew or loosen the velocity adjustment screw by turning it counter-
clockwise. Rotate the velocity adjustment screw counter-clockwise in small
increments (1/4 turn or less), stopping between slight turns to test velocity, until
desired velocity is achieved. Do not back the adjuster out passed being flush.
Stop if you hear an air leak, and adjust back in a 1/4 turn. A paintball specific
radar chronograph should be used to accurately measure your velocity.
-To Decrease Velocity
Tighten or screw-in the velocity adjustment screw by turning it Clockwise.
Rotate the velocity adjustment screw Clockwise in small increments (1/4 turn
or less), stopping between slight turns to test velocity, until desired velocity is
achieved. A paintball specific radar chronograph should be used to accurately
measure your velocity
Notes:
- This marker was designed with safety and safety standards in mind. If you attempt
to shoot paintballs at a higher velocity than established safety standards, the
marker may not function properly.
- If you attempt to operate the marker at extremely high velocities, the internals
will not function properly.
- This marker is not designed to shoot above the safety limits established by industry
standards but under certain conditions it may. It is therefore important to check the
velocity each time before playing with your Mini.