Owner`s manual

28040-3-0511Page 24
          


B. BEFORE LIGHTING 


WHAT TO DO IF YOU SMELL GAS
 
 
 
 

     

C. Use only your hand to push in or turn the gas control
           



 



1. Openbottomlouverassembly(ifapplicable).
2. Set REMOTE/OFF/ON switch to "OFF."
3. Turn off all electric power to the appliance if service is to be
performed(ifapplicable).
4. Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
5. Closebottomlouverassembly(ifapplicable).
1. STOP! Read the safety information label.
2. Open bottom louver assembly (if
applicable).
3. Set REMOTE/OFF/ON switch to
"OFF."
4. Turn off all electric power to the ap-
pliance(ifapplicable).
5. Push in gas control knob slightly and
turn clockwise to "OFF."
NOTE: Knob cannot be turned from "PILOT"
to "OFF" unless knob is pushed in slightly. Do
not force.
6. Wait ten (10) minutes to clear out any gas.
Then smell for gas, including near
theoor.Ifyousmellgas,STOP!
Follow "B" in the safety information
above. If you do not smell gas, go
to the next step.
7. Find pilot - Follow metal tube from
gas control. The pilot is in front of
the burner on the right side.
8. Turn gas control knob counter-
clockwise to "PILOT."
9. Push in control knob all the way and hold in. Repeatedly
push the Piezo Ignitor Button until the pilot is lit. Continue
toholdthecontrolknobinforaboutone(1)minuteafter
the pilot is lit. Release knob, and it will pop back up. Pilot
should remain lit. If it goes out, repeat steps 5 through 9.
• Ifknob doesnot pop up when released,STOPand
IMMEDIATELY call a qualied service technician or
gas supplier.
• Ifthepilotwillnotstaylitafterseveraltries,turnthegas
control knob to "OFF" and call your service technician
or gas supplier.
10. Turn gas control knob counterclockwise to
"ON."
11. Set REMOTE/OFF/ON switch to desired setting.
12. Turnonallelectricpowertotheappliance(ifapplicable).
13. Closebottomlouverassembly(ifapplicable).
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION.
THERMOCOUPLE
(NATURAL)
ELECTRODE
PILOT
THERMOPILE
REMOTE
OFF
ON
THERMOCOUPLE
(LPG)
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION.
THERMOCOUPLE
(NATURAL)
ELECTRODE
PILOT
THERMOPILE
REMOTE
OFF
ON
THERMOCOUPLE
(LPG)
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION.
THERMOCOUPLE
(NATURAL)
ELECTRODE
PILOT
THERMOPILE
REMOTE
OFF
ON
THERMOCOUPLE
(LPG)
MILLIVOLT CONTROL VALVE LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
WARNING:
