Owner`s manual

28040-3-0511 Page 29
• Continuingbeepsconrmtheignitionisinprocess.
• Oncepilotignitionisconrmed,thereismaingasow.
• After the ignition the remote will go automatically into tem-
perature control mode.
Caution: If the pilot does not stay lit after several tries, turn the
main valve knob to OFF and follow the instructions "Turn Off Gas
toAppliance"(Seepage26).
Figure 25 
TO TURN OFF APPLIANCE
Press OFF button on remote handset.
Notice: Press (smallame)toturnmaingastopilotgas.
ADJUSTMENT - FLAME HEIGHT

• In standby mode: Press  (large ame) to increase ame
height.
• Press (smallame)todecreaseameheightortosetap-
plianceatpilotame.
• Forneadjustmenttapthelarge/smallames.

Handset
• If (largeame)or (smallame)arepressedfor0.5sec-
onds,themotorwillturnthevalvetohighreorpilotame.
Caution: If the appliance will not operate, follow the instructions
"TURNOFFGASTOAPPLIANCE"(Seepage26).


• Press OFF and  (small ame) until display changes from
Fahrenheit/12 hour clock to Celsius/24 hour clock and vice
versa.
AUTOMATIC OPERATION
WARNING
Wiring of valve and receiver must be completed before starting
ignition. Failure to do so could damage the electronics.
SETTING THE ELECTRONICS CODE
Notice: The remote control and receiver are pre-programmed at
the factory. However, if for some reason they do not communicate
to each other, follow these steps to re-program.

A code is selected automatically for all Mertik Maxitrol electronics
from among 65,000 random codes available. The receiver has to
learn the code of the handset:
• Pressandholdthereceiver'sresetbutton(seegure23)until
you hear two (2) beeps.After the second, longer beep, re-
lease the reset button.
• Withinthesubsequent20secondspressthe (smallame)
button on the remote handset until you hear an additional long
beepconrmingthecodeisset.
Notice: This is a one time setting only, and is not required when
changing the batteries in the remote or receiver.
Figure 24
TO TURN ON APPLIANCE
WARNING
When pilot ignition is conrmed, motor turns automatically to
maximumameheight.
• Turn MANUAL knob to the ON, full counterclockwise
position(SeeFigure25).
• PlaceON/OFFswitch(ifequipped)in (ONposition).

• SimultaneouslypressandholdtheOFF and (largeame)
buttons until a short beep conrms the start sequence has
begun; release buttons.
INTERMITTENT PILOT REMOTE ELECTRONIC IGNITION AND
CONTROL SYSTEM