Owner`s manual

28040-3-0511 Page 31
7. With the MANUAL knob in MAN position a manual pi-
lot valve operator and piezo igniter are accessible.

Fully push down manual pilot valve operator and hold
in,tostartpilotgasow.   
Immediately light the pilot with a match, while continuing to
holdinthemanualpilotvalveoperatorforaboutone(1)min-
ute after the pilot is lit. Release manual pilot valve operator. If
pilotdoesnotstaylit,waitve(5)minutesandrepeat.

Change the ignition cable from the receiver to the valve. Use
the push piezo igniter to ignite. If pilot does not stay lit, wait
ve(5)minutesandrepeat.   
Caution: If the pilot does not stay lit after several tries, turn
thegascontrolknob(mainvalveknob)toOFF and proceed
to step 11.
8. If applicable, reinstall the top cover on the burner base before
proceeding.
9. Turn MANUAL knob to the ON, full counterclockwise
position.
10. Turn main valve knob to the full ON, full counter-
clockwise position.
11. If the appliance will not operate, follow the instructions "TURN
OFF GAS TO APPLIANCE" and call the service technician or
gas supplier.
TURN OFF GAS TO APPLIANCE
• PressOFFbuttononremote.
• Follow appliance instructions for gaining accessibility tothe
gas control.
• PlaceON/OFFswitchinO(offposition).
• Turnmainvalve knob to the OFF full clockwise
position.
• Replaceappliancetopcover.
MISCELLANEOUS

Receiver:
three short beeps will sound when motor turns
Remote with display:
"BATT" will appear on display
Notice: Thermostatic Displays/Handsets: If the battery of the
handset is low or if the transmitter is out of the communi-
cation range, the motor turns down the valve to pilot gas
after 6 hours.
Notice: WithverylowbatterytheGV60systemshutsoffthere
completely. This will not happen if the power supply is
interrupted.

Battery replacement is recommended at the beginning of each
heating season. Do not use metal tools to remove batteries. Using
a metal tool could cause a short that may damage the receiver.
Location of Receiver
When the RF-receiver is placed in the appliance, the surrounding
metal can reduce reception considerably. The position of th an-
tennaonthereceiveralsoinuencesreception.Itisrecommended
to straighten the antenna. The antenna must not come in contact
or cross the ignition wire, this may render the receiver inoperable.
CAUTION: Keep receiver free from debris and dirt. Protect
the receiver with a plastic bag until all construc-
tion is complete.
PIEZO IGNITER
ON/OFF SWITCH
IN POSITIONON
8 WIRE
RECEIVER JACK
MICROSWITCH
MAIN VA LVE KNOB
IN POSITIONOFF
MANUAL PILOT
VA LVE OPERATOR
MANUAL KNOB
IN POSITIONMAN
CONNECTION
PIEZO IGNITER
TAB 2.8 X 0.8 mm
CUTOUT FOR
PILOT GAS
ADJUSTMENT
MANUAL KNOB
IN POSITION FOR
AUTOMATIC IGNITION
Figure 27
Figure 28
INTERMITTENT PILOT REMOTE ELECTRONIC IGNITION AND
CONTROL SYSTEM