Owner`s manual

28040-3-0511 Page 33
Flamesfromthepilot(frontcenterofburner)aswellasthemain
ameshouldbevisuallycheckedasthereplaceisinstalled.
Innormaloperationatfullrateafter10to15minutes,theame
appearanceshouldbesetsofyellowames.
Notice:Allameswillberandombydesign,ameheightwillgo
up and down.
Avoidanydraftsthatalterburneramepatterns.Donotallowfansto
blowdirectlyintoreplace.Donotplaceablowerinsidetheburner
areaoftherebox.Ceilingfansmaycreatedraftsthatalterame
patterns. Sooting and improper burning will result.
During manufacturing, fabricating and shipping, various components
ofthisappliancearetreatedwithcertainoils,lmsorbondingagents.
These chemicals are not harmful, but may produce annoying smoke
and smells as they are burned off during the initial operation of the
appliance, possibly causing headaches or eye or lung irritation. This
is a normal and temporary occurrence.
The initial break-in operation should last 2-3 hours with the burner
at the highest setting. Provide maximum ventilation by opening
windows or doors to allow odors to dissipate. Any odors remaining
after this initial break-in will be slight and will disappear with
continued use.
Once the break in operation has been completed, adjust the heater
to the desired output and then replace the surround.
OPERATION INSTRUCTIONS/FLAME APPEARANCE