Owner`s manual

28040-3-0511Page 8
Notice: Duringinitialringofthisunit,itspaintwillbakeout,and
smoke will occur. To prevent triggering of smoke alarms, ventilate
the room in which the unit is installed.
Installation on Rugs and Tile
If this appliance is installed directly on carpeting, tile or other
combustiblematerialotherthanwoodooringtheapplianceshall
be installed on a metal or wood panel extending the full width and
depth of the appliance.
Thebasereferredtoabovedoesnotmeanthere-proofbaseas
used on wood stoves. The protection is for rugs that are extremely
thick and light colored tile.
Solid-fuels shall not be burned in a masonry or UL 127 factory-
builtreplaceinwhichanunventedroomheaterisinstalled.

Installation and replacement of gas piping, gas utilization equipment
or accessories and repair and servicing of equipment shall be
performedonlybyaqualiedagency.Theterm"qualiedagency"
meansanyindividual,rm,corporationorcompanywhicheitherin
person or through a representative is engaged in and is responsible for
(a)theinstallationorreplacementofgaspipingor(b)theconnection,
installation, repair or servicing of equipment, who is experienced in
such work, familiar with all precautions required and has complied
with all the requirements of the authority having jurisdiction.
State of Massachusetts: The installation must be made by
a licensed plumber or gas tter in the Commonwealth of
Massachusetts.
Sellersofunventedpropaneornaturalgas-redsupplemental
room heaters shall provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
In the Sate of Massachusetts, unvented propane and natural
gas-redspaceheatersshallbeprohibitedinbedroomsand
bathrooms.
The installation must conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code, ANSI Z223.1.*
*Available from the American National Standards Institute, Inc. 1430
Broadway, New York, N.Y. 10018.
High Altitudes
Foraltitudes/elevationsabove2,000feet(610m),ratingsshouldbe
reducedattherateof4percentforeach1,000feet(305m)above
sea level. Contact the manufacturer or your gas company before
changingspud/oricesize.
Well Head Gas Installations
Some natural gas utilities use "well head" gas. This may affect the
Btu output of the unit. Contact the gas company for the heating value.
Contact the manufacturer or your gas company before changing
spud/oricesize.
WARNING
Thisapplianceisequippedfor(naturalgasorpropane)gas.Field
conversion is not permitted.
Instructions to Installer
1. Installer must leave instruction manual with owner after
installation.
2. Installermusthaveownerlloutandmailwarrantycardsupplied
with unvented room heater.
3. Installer should show owner how to start and operate unvented
room heater.
Always consult your local Building Department regarding regulations,
codes or ordinances which apply to the installation of an unvented
room heater.
This appliance may be installed in an aftermarket* manufactured
(mobile)home,wherenotprohibitedbystateorlocalcodes.
*Aftermarket: Completion of sale, not for purpose of resale, from
the manufacturer.
This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other
gases.
WARNING
ANY CHANGE TO THIS HEATER OR ITS CONTROLS CAN
BE DANGEROUS.


poisoning.
ThisseriesisdesigncertiedinaccordancewithAmericanNational
Standard Z21.11.2 by the Canadian Standards Association
Laboratories as an Unvented Room Heater and should be installed
according to these instructions.
Any alteration of the original design, installed other than as
           


Millivolt 3 Series Only

When you ignite the pilot, the thermocouple produces millivolts
(electricalcurrent)whichenergizesthemagnetinthegasvalve.
After 30 seconds to 1 minute time period you can release the gas
controlknobandthepilotwillstayON.Allow your pilot ame to
operateanadditionalone(1)totwo(2)minutesbeforeyouturnthe
gas control knob from the PILOT position to the ON position. This
timeperiodallowsthemillivolts(electricalenergy)tobuild-uptoa
sufcientlevelallowingthegascontroltooperateproperly.

All correspondence should refer to complete Model Number, Serial
Number and type of gas.
INTRODUCTION