Owner`s manual

ManualsBrandsEmpire ManualsDomestic AppliancesVFP36SB2EL-2

INSTALLATION INSTRUCTIONS

AND OWNER'S MANUAL

DO NOT ATTEMPT TO MODIFY OR ALTER THE CONSTRUC-

TION OF THE FIREBOX OR ITS COMPONENTS. ANY MODI-

FICATION OR ALTERATION OF CONSTRUCTION MAY VOID

THE WARRANTY OF THIS FIREBOX.

CHILDREN AND ADULTS SHOULD BE ALERTED TO THE

HAZARDS OF HIGH SURFACE TEMPERATURE AND

SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING IG-

NITION.

YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED

WHEN THEY ARE IN THE SAME ROOM AS THE FIREBOX.

PREMIUM UNIVERSAL FIREBOX FOR

ALL VENT-FREE LOG SETS

SEE-THROUGH FIREBOX MODELS:

VFP36SB2E(L,F)-3

PENINSULA FIREBOX MODELS:

VFP36PB2E(L,F)-3

GAS-FIRED

ANSI Z21.91 Ventless Fireplace Enclosures for use with any

ANSI Z21.11.2 Gas Fired Decorative Type Unvented Room

Heaters

EMPIRE

Comfort Systems

WARNING: Improper installation, adjustment, alteration,

service or maintenance can cause injury or property dam-

age. Refer to this manual. For assistance or additional infor-

mation, consult a qualied installer, service agency or the

gas supplier.

Carefully review the instructions supplied with the decora-

tive type unvented room heater for the minimum replace

size requirement.

DO NOT INSTALL A VENT-FREE LOG SET IN THIS FIREBOX,

UNLESS THIS FIREBOX MEETS THE MINIMUM DIMENSIONS

REQUIRED FOR THE INSTALLATION.

FOR USE ONLY WITH A LISTED GAS-FIRED UNVENTED

DECORATIVE ROOM HEATER NOT TO EXCEED

40,000 BTU/H.

DO NOT BUILD A WOOD FIRE.

Installer: Leave this manual with the appliance.

Consumer: Retain this manual for future reference.

— Do not store or use gasoline or other ammable va-

pors and liquids in the vicinity of this or any other ap-

pliance.

— WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any

phone in your building.

• Immediately call your gas supplier from a neigh-

bor’s phone. Follow the gas supplier’s instruc-

tions.

• If you cannot reach your gas supplier, call the re

department.

— Installation and service must be performed by a quali-

ed installer, service agency or the gas supplier.

WARNING: If the information in these instructions are

not followed exactly, a re or explosion may result caus-

ing property damage, personal injury or loss of life.

Page 1

Summary of content (20 pages)

PAGE 1
EMPIRE Comfort Systems INSTALLATION INSTRUCTIONS AND OWNER'S MANUAL PREMIUM UNIVERSAL FIREBOX FOR ALL VENT-FREE LOG SETS SEE-THROUGH FIREBOX MODELS: VFP36SB2E(L,F)-3 PENINSULA FIREBOX MODELS: VFP36PB2E(L,F)-3 GAS-FIRED WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer, service agency or the gas supplier.
PAGE 2
TABLE OF CONTENTS SECTION PAGE Important Safety Information ................................................................................... 3 Introduction.............................................................................................................. 3 Clearances.......................................................................................................... 4 - 5 Firebox Installation Instructions............................................................................
PAGE 3
IMPORTANT SAFETY INFORMATION The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1 (latest edition) and to the National electrical Code, ANSI/NFPA70 (latest edition). NOTE: Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a qualified service person.
PAGE 4
CLEARANCES Sidewall Clearances: The clearance from the inside of the firebox to perpendicular combustible side wall should not be less than 1 3/4". See Figures 1a and 1b. Combustible material clearance from front of firebox: 36" minimum Firebox Side and Back Clearances: The firebox outer casing side(s) require a minimum 1/2" clearance to combustibles. Top Framing and Finishing: Combustible framing may rest on top of standoffs.
PAGE 5
CLEARANCES Ceiling Clearances: The ceiling height should not be less than 42" from the top of the hood. See Figures 3a and 3b. CEILING Mantel Clearances: Vent free firebox models must use the hood supplied with the firebox, or one of the optional hood kits available for each model. If a combustible mantel is installed, it must meet the clearance requirements detailed below. Grate Clearance: The minimum clearance between the front legs of the grate and the front edges of the firebox is 1 1/2".
PAGE 6
FIREBOX INSTALLATION INSTRUCTIONS Any vent-free Gas Log Heater must be “For use with approved ANSI Z21.11.2 unvented room heater.” Follow and complete the installation instructions of the gas log set and the requirements of this firebox. Note: On Peninsula models, a maximum weight of 250 lbs. is recommended when construction materials are supported by the top standoff spacers. Check all fittings for leaks before lighting the gas log set.
PAGE 7
FIREBOX INSTALLATION INSTRUCTIONS (continued) 2 9/16” 2 9/16” G C 2 9/16” SEE THRU LOUVERED OR FLUSH DMNA PENINSULA LOUVERED OR FLUSH H F O J J O L I L H F K K DMNA I E B E B LOUVERED PANELS FLUSH PANELS VFP36SB VFP36PB VFP36SB VFP36PB A 38 1/8" 38 1/8" 38 1/8" 38 1/8" B 39" 39" 39" 39" C 24" 24" 24" 24" D 25 1/2" 25 1/2" 25 1/2" 25 1/2" E 36" 36" 36" 36" F 34 1/4" 35 1/4" 34 1/4" 35 1/4" G 29 1/8" 29 1/8" 29 1/8" 29 1/8" H 41 1/8" 41 1/8" 4
PAGE 8
FIREBOX INSTALLATION INSTRUCTIONS (continued) Locating Firebox Place firebox in framed opening. Attach the framing brackets to the firebox and secure firebox to framing. Different hole locations can be used for finishing materials with thicknesses of 3/8", 1/2" and 3/4". Secure the brackets with screws provided using two per framing bracket. See Figure 7. Framing brackets should fit directly against framing material. Use at least one nail or screw per bracket to secure in place.
PAGE 9
INSTALLING HOOD (continued) Extended Hoods If your non-combustible facing material is over 1" in thickness and will be used to finish this firebox, extended hoods are available that will extend out 2" farther into the room. Extended hoods are not available for the peninsula open ends. Contact your local dealer for details.
PAGE 10
WIRING INSTRUCTIONS FOR INSTALLING A DUAL SWITCH / RECEPTACLE In order to install both the optional Blower and Accent Light accessories, it will be necessary to install the junction box so that the Duplex Receptacle wiring is split. This will allow each side of the receptacle to operate independently off separate wall switches. See diagram below.
PAGE 11
OPTIONAL SINGLE SPEED BLOWER INSTALLATION INSTRUCTIONS Attention: Install blower assembly before connecting gas inlet supply line. Wiring The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, if an external electrical source is utilized.
PAGE 12
4. Insert blower assembly into interior, bottom of firebox. Position blower assembly so that you align the notch on back of blower assembly with the center screw on side/end panel, then push the blower assembly against firebox outer panel. The blower wheel must be centered with the side/end wall of the firebox. The magnets on the back and bottom of blower assembly will sufficiently hold blower assembly in place. See Figure 16. 5.
PAGE 13
Blower Motor The blower motor does not have oiling holes. Do not attempt to oil the blower motor. 110 VOLT AC JUNCTION BOX FAN/MOTOR ASSEMBLY Blower Wheels The blower wheels will collect lint and could require periodic cleaning. If the air output decreases or the noise level increases, it indicates a dirty blower wheel. Remove fan and clean blower wheels.
PAGE 14
PARTS LIST Part Number Index Number VFP36SB2EL VFP36SB2EF VFP36PB2EL VFP36PB2EF 1 - - - - 2 17149 17149 17149 17149 TOP STANDOFF 3 R9655 R9655 R9655 R9655 INSULATION - TOP 4 24067 24067 24067 24067 INSULATION SUPPORT 5 R7052 R7052 R7052 R7052 SCREEN ROD Description FIREBOX ASSEMBLY 6 - - R9633 R9633 SCREEN ROD 7 R9631 R9631 R9631 R9631 BRICK PANEL - SIDE BULK 8 19945 19945 19945 19945 BRICK LINER BRACKET 9 20145 20145 20145 20145 HOOD 10 - - 240
PAGE 15
SEE-THROUGH FIREBOX PARTS VIEW 2 3 3 23 4 4 12 7 11 8 9 5 13 27 22 1 8 23 7 12 24 24 11 20 27 13 16 9 17 19 17 18 18 19 20 27451-5-0614 Page 15
PAGE 16
PENINSULA FIREBOX PARTS VIEW 2 3 3 4 7 23 4 9 8 11 5 13 27 22 1 6 24 23 11 12 12 10 24 25 14 26 13 16 19 20 21 15 9 17 17 18 18 19 Page 16 20 27451-6-0614
PAGE 17
ACCESSORIES Accessory Description Model Numbers Fan Kit Designed to provide forced air flow. Note: For use with louvered or flush panel models.
PAGE 18
ACCESSORIES (continued) Extended 4" Hoods Extended hoods that extend out 2" farther than the standard hoods, to accommodate thicker surround materials. Available as optional kits in Black, Brass, Hammered Pewter, and Stainless Steel finishes. Contact dealer for all available optional hood accessories Note: Not available for Peninsula open ends. Louvers Styles include Slat, Mission, Arch, and Leaf Patterns. Available as optional kits in Black, Brass, Hammered Pewter, and Stainless Steel finishes.
PAGE 19
MASTER PARTS DISTRIBUTOR LIST To Order Parts Under Warranty, please contact your local Empire dealer. See the dealer locator at www.empirecomfort. com. To provide warranty service, your dealer will need your name and address, purchase date and serial number, and the nature of the problem with the unit. To Order Parts After the Warranty Period, please contact your dealer or one of the Master Parts Distributors listed below. This list changes from time to time.
PAGE 20
WARRANTY Empire Comfort Systems Inc. warranties this hearth product to be free from defects at the time of purchase and for the periods specified below. Hearth products must be installed by a qualified technician and must be maintained and operated safely, in accordance with the instructions in the owner’s manual. This warranty applies to the original purchaser only and is not transferable. All warranty repairs must be accomplished by a qualified gas appliance technician.