Installation Manual

6
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This module has been tested for compliance to FCC Part 15
The module is tested for standalone mobile RF exposure use condition. Any other usage conditions such as
co-location with other transmitter(s) or being used in a portable condition will need a separate reassessment
through a class II permissive change application or new certification.
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or simultaneous
transmission with other transmitter(s) or portable use will require a separate class II permissive change re-
evaluation or new certification.
2.4 Limited module procedures
Please addressed (same as module request letter)
2.5 Trace antenna designs
Not applicable.
2.7 Antennas
The following antennas have been certified for use with this module; antennas of the same type with
equal or lower gain may also be used with this module. The antenna must be installed such that 20 cm
can be maintained between the antenna and users.
Antenna Type
Loop Antenna
Antenna connector
N/A