User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 3–22
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
Figure 3–7. User Data I/O Mode Configurations – Stand-Alone
(h) ARINC 429 IRS Bus Interface – Stand-Alone
In Stand-Alone Mode installations, navigational information (refer to "System
Description" on page 1-1 for more information) is provided to the HSD through
the high-speed ARINC 429 IRS bus interface. The IRS bus connects through the
top plug of the ARINC 600 connector to the HSD as follows:
• IRS A to TP4J
• IRS B to TP4K
(i) Antenna Interface – Stand-Alone
The ARINC 741 antenna subsystem BSU is interconnected to the HSD as
specified in
Table 3–9.
Table 3–9. Stand-Alone Mode HSD to BSU Interconnects
Signal Name
Signal Source
Signal
Destination
HSD
Transceiver
Mechanical
HGA
Phased-Array or
Conformal HGA
HPA MUTE A Port BSU-G HSD TP3A
STBD BSU-G HSD TP3C
HPA MUTE B Port BSU-H HSD TP3B
STBD BSU-H HSD TP3D