User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 3–38
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
Figure 3–12. User Data I/O Mode Configurations – Combined/Selective
(g) ARINC 429 IRS Bus Interface – Combined/Selective
In HCM Combined Mode and Selective Mode installations, navigational
information (refer to
"System Description" on page 1-1 for details) is provided to
the HSD through the high-speed ARINC 429 IRS bus interface. The IRS bus
connects through the top plug of the ARINC 600 connector to the HSD as follows:
• IRS A to TP4J
• IRS B to TP4K
(h) Antenna Interface – Combined/Selective
The SATCOM Aero H/H+ system provides the interface to the antenna. Refer to
Honeywell documentation for specific details.
(i) RF Splitter Installation – Combined/Selective
Refer to the Interconnection Diagrams for cabling details. Refer to Table 3–19
for a list of the required cable assembly parts. Substitutions using different parts
of equivalent functionality are acceptable.
Note: Before installing the RF splitter, read all of the steps included in the
following splitter installation procedure.
Note: Actual splitter mounting location may vary depending on the placement of
the existing RFU and HPA assemblies.