User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 4–23
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
16 Channel card
category
• Offers an LRU configuration choice of:
•0 for SAT-906
• 1 for Stand-Alone
• 2 for HW Strapping
•3 for MCS3000
•4 for MCS6000
•5 for MCS7000
• 6 for MCS Combined
• 7 for Stand-Alone without antenna
• 8 for HCM Combined (Honeywell
Combined Mode)
• 9 for Cooperative Rockwell Collins
SAT-906
• 10 not used
• 11 for HSD-X Network (Multi-Channel
AERO)
• 12 for HSD-X Network without antenna
(Multi-Channel Non AERO)
• 13 for VIPER
• Default is “2” (where hardware is read on
power-up)
17 Viper antenna gain • Used to configure the nominal antenna gain
used by the HSD when operating in Viper
Mode—presuming that the HSD is connected
to an antenna that does not provide antenna
status words
18 Viper HPA/ANT loss • Used to configure the nominal antenna gain
used by the HSD when operating in Viper
Mode—presuming that the HSD is connected
to an antenna that does not provide antenna
status words
Table 4–11. Menu 3, Item 'M' EEPROM Parameter Descriptions (Version 7.0)
Parameter
#
Parameter Title Description