User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 4–65
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
Figure 4–38. Call Initialization (Aero H/H+ call)
Figure 4–39. Stable Connection with one Aero H/H+ call
Figure 4–40. Connection with two Aero H/H+ calls
Figure 4–41. Connection with two Aero H/H+ calls and one M4 (Swift64) call
Figure 4–42. Connection with two M4 (Swift64) calls and one Aero H call
CHANNEL CARD #1 #2
EIRP/WATTS 0.0/0 0.0/0
HPA (ITS): 9.0 WATTS A CHANNEL CARDS: 0.0 WATTS ANT GAIN: 12
15:10:02 PERMITTED UNDERDRAFT: 0.0 dB ADD M4 CALL: 20 WATTS
AERO WATTS: USED=10 RESERVED=23 HPA=36 WATTS HPA GAIN=62.2 dB
CHANNEL CARD #1 #2
EIRP/WATTS 0.0/0 0.0/0
HPA (ITS): 2.2 WATTS H CHANNEL CARDS: 0.0 WATTS ANT GAIN: 12
15:11:24 PERMITTED UNDERDRAFT: 0.0 dB ADD M4 CALL: 20 WATTS
AERO WATTS: USED=02 RESERVED=14 HPA=36 WATTS HPA GAIN=61.2 dB
CHANNEL CARD #1 #2
EIRP/WATTS 0.0/0 0.0/0
HPA (ITS): 4.0 WATTS A CHANNEL CARDS: 0.0 WATTS ANT GAIN: 12
15:14:09 PERMITTED UNDERDRAFT: 0.0 dB ADD M4 CALL: 20 WATTS
AERO WATTS: USED=04 RESERVED=16 HPA=36 WATTS HPA GAIN=61.7 dB
CHANNEL CARD #1 #2
EIRP/WATTS 17.5/6 0.0/0
HPA (ITS): 15.9 WATTS A CHANNEL CARDS: 6.2 WATTS ANT GAIN: 12
15:15:48 PERMITTED UNDERDRAFT: 3.0 dB ADD M4 CALL: 10 WATTS
AERO WATTS: USED=04 RESERVED=17 HPA=36 WATTS HPA GAIN=62.3 dB
CHANNEL CARD #1 #2
EIRP/WATTS 18.5/8 18.5/8
HPA (ITS): 17.9 WATTS A CHANNEL CARDS: 15.7 WATTS ANT GAIN: 12 =04
RESERVED=17 HPA=36 WATTS HPA GAIN=62.6 dB
12:16:10 PERMITTED UNDERDRAFT: 4.0 dB ADD M4 CALL: 08 WATTS
AERO WATTS: USED=02 RESERVED=15 HPA=36 WATTS HPA GAIN=62.6 dB