User's Manual

Page 4–72
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
The ADT_LOAD application prompts the user to select a “Target”.
8. From the “Which Target” menu:
• To load channel card application software (for example: appl41.hex,
cfig41.hex ) to channel card #1, press
1
• To load channel card application software (for example: appl41.hex,
cfig41.hex) to channel card #2, press
2
9. Press Enter.
The load application prompts you to type in a filename.
10. Type the appropriate filename for the software being loaded to the HSD Channel
Card (for example appl41.hex or cfig41.hex), and then press
Enter.
The application prompts you to select a COM port.
11. Select the COM port on your computer connected to the HSD.
12. Type the appropriate COM port (1 or 2—typically 1), and then press Enter.
13. To start the load, press Enter.
Communication with the HSD transceiver is established. The following screen
appears. A percentage (%) progress indicator appears on the screen showing
load status. Once the load is complete, a confirmation message briefly appears
on the screen indicating that the file has been successfully loaded. The DOS
window then closes and the HSD resets.
HSD/HST LOADER Vx.x -- Mon Mar 24 12:12:17 2003
which target ?
0 = control processor
1 = channel card #1
2 = channel card #2
3 = HPA application
4 = data i/o card
5 = HPA application with manual setup
6 = HPA application plus boot with manual setup
7 = HPA application plus boot
8 = channel card #1 boot code
9 = channel card #2 boot code
11 = channel card #1 pic code
12 = channel card #2 pic code
13 = HCM application
14 = HST ORT
15 = HSD ORT
?