User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page E–1
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
APPENDIX E: RECORD OF ACCOMPLISHMENT
To record the accomplishment of a software service bulletin, complete a copy of this form
for each unit (serial number) that has been upgraded.
Fax or e-mail all Record of Accomplishments (one for each unit) to EMS Technologies. If
you require assistance, contact EMS SATCOM Product Support.
EMS SATCOM Product Support: 1.888.300.7415 (routed to a mobile after regular
business hours)
E-mail: hsd.help@emstechnologies.ca
FAX:1.613.591.0797
SOFTWARE STATUS AFTER ACCOMPLISHMENT OF SERVICE BULLETIN:
HSD IDENTIFICATION
Part No Serial No
Hardware Revision Software Revision
No. (LI revision)
AIRCRAFT IDENTIFICATION
Type Serial No
Registration (Tail) No
CUSTOMER INFORMATION
Company Phone No
Contact Name Signature
DEALER
Company Phone No
Contact Name Signature
Application Channel Cards HPA Data I/O
HSD HSD-X HSD HSD-X HSD HSD-X HSD HSD-X
Example 4.3 C30 V9A4 DIOMain
1.17.elf
Original
Software
New Software
Installed