User's Manual
Table Of Contents
- Introduction
- System Description
- 1. Purpose of Equipment
- 2. Equipment Covered
- 3. Equipment Description
- A. Applicable Documents
- B. Reference Documents
- C. Equipment Specifications
- D. Mechanical Description
- E. Electrical Description
- F. System Interface Descriptions
- G. User Interfaces
- (1) Stand-Alone Mode User Interfaces
- (2) Collins Cooperative Mode User Interfaces
- (3) Honeywell Combined Mode User Interfaces
- (4) Selective Mode User Interfaces
- (5) Multi-Channel Configurations
- (6) ISDN Circuit-Switched Data Interface
- (7) RS-232 Interface
- (8) Ethernet Data Interface
- (9) ISDN S/T Interface
- (10) Maintenance Port Interface
- H. Initiated-Self-Test
- I. Owner Requirements Table
- 4. Inmarsat System Overview
- 5. HSD Modes and Configuration Descriptions
- System Operation
- 1. Introduction
- 2. Activating HSD Transceivers
- 3. Configuring HSD Systems
- 4. Using the HSD System
- Installation
- 1. Introduction
- 2. Advisories
- 3. Pre-Installation Inspection
- 4. Unpacking and Inspecting Equipment
- 5. Cabling and Connector Requirements
- 6. ARINC 600 Trays and Connectors
- 7. Mechanical Installation
- 8. Electrical Installation
- 9. Outline/Installation and Interconnection/Contact Assignment Diagrams
- Test and Fault Isolation
- 1. Introduction
- 2. Operational and Diagnostic Testing
- 3. Troubleshooting and Fault Isolation
- 4. Adjustment/Alignment Procedures
- 5. Modification History
- Maintenance and Repair
- 1. General
- 2. Maintenance
- 3. Repair
- 4. Instructions for Continued Airworthiness, FAR 25.1529
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: RJ-45 Cable Termination Details
- Appendix D: Installation Checklist
- Appendix E: Record of Accomplishment
- Appendix F: RF Splitter
Page 2–9
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
Figure 2–2. System Setup and Mapping for Incoming Calls (Fixed-to-Mobile)
Note: Refer to Table 2–2, Table 2–3, and Table 2–4 for the default MSNs assigned
within the HSD system.
Table 2–2. IMN and MSN Assignments for ISDN Bus #1
Channel Card # 1 Forward ID XAXXXX
Service Type IMN MSN
64 kbps Speech 60xxxxxx1 (
See Note below)MSN 40
3.1 kHz Audio 60xxxxxx2 MSN 20
56 kbps Data 60xxxxxx3 MSN 30
64 kbps Data 60xxxxxx4
60xxxxxx5
60xxxxxx6
MSN 10
MSN 11
MSN 12
4.8 kbps LSV 76xxxxxx7 through to 760xxxx22 MSN 80 through to 95
Table 2–3. IMN and MSN Assignments for ISDN Bus #2
Channel Card # 2 (if installed) Forward ID XBXXXX
Service Type IMN MSN
64 kbps Speech 60xxxxx23 MSN 40
3.1 kHz Audio 60xxxxx24 MSN 20
56 kbps Data 60xxxxx25 MSN 30