User's Manual
Table Of Contents
- Introduction
- System Description
- System Operation
- Installation
- Test and Fault Isolation
- Maintenance and Repair
- 1. Maintenance
- 2. Repair
- 3. Instructions for Continued Airworthiness
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: Installation Planning Checklist
- Appendix D: Installation Checklist
- Appendix E: Inmarsat Cause Codes
- Appendix F: Setting Up SBB
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-X and HSD-Xi High-speed Data Terminal
23-15-30 F-7
8 MAY 09
• SBB:BACKGROUND@APN=my.apn.com for Background IP
service that uses specific access point name
• SBB:BACKGROUND@USER=username@PASS=password for
Background IP service that uses a specific username and password.
Replace “username”, “password”, and “my.apn.com” with your username,
password, and APN IP address.
This defines the primary PDP context as a background SBB connection.
NOTE: Some routers do not support dial strings. To access a service,
configure the default service name in the data I/O card, and the
HSD-X and HSD-Xi terminal will add the service name to the call.
3. Creating Connections for Other Services
You can create a connection for every service you use on your computer, such as 32 kbps
and 64 kbps services.
To create a connection:
• Follow the procedure above for Configuring a Standard IP Primary PDP Context, and, in
step 16, type one of the following service names:
• SBB:STREAM32K for 32 K streaming service
• SBB:STREAM64K for 64 K streaming service
• SBB:STREAM128K for 128 K streaming service