User's Manual
Table Of Contents
- Introduction
- System Description
- System Operation
- Installation
- Test and Fault Isolation
- Maintenance and Repair
- 1. Maintenance
- 2. Repair
- 3. Instructions for Continued Airworthiness
- Appendix A: Inmarsat Satellite Beam Coverage
- Appendix B: Troubleshooting Checklist
- Appendix C: Installation Planning Checklist
- Appendix D: Installation Checklist
- Appendix E: Inmarsat Cause Codes
- Appendix F: Setting Up SBB
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-X and HSD-Xi High-speed Data Terminal
23-15-30 C-2
8 MAY 09
Fwd ID
System mode
Data I/O
(if applicable)
SDI
3. Wiring
Antenna Multi-Control
BITE A/B
HPA Mute A/B
Power
ISDN:
Wire the ISDN line. Channels 1 and 2 operate over ISDN 1.
ISDN-1
Ethernet:
Wire the Ethernet port for SBB.
Ethernet-1
Inertial Navigation System (INS)
Analog Tip/Ring (POTS)
CEPT-E1, Future PBX applications (optional)
4. Configuration
Program the Land Earth Station (LES) Access Codes
Configure the CNX Cabin Gateway if required
Installation Planning Steps